Try unplugging the AFM
Are all the injection parts off the same engine as the ecu ?, AFM,
injectors, inlet manifold, throttle body etc ?
Has the throttle body been removed ?, was the gasket under it the
correct type (Black plastic and metal inlet manifolds use different gaskets.
Are you sure theres not a air leak somewhere, play a hose around the
inlet manifold and throttle body, if the engine note suddenly changes
the water has been sucked into a gap and blocked it momentarily.
Jim
On 01/06/2010 12:29, Steve Kodz wrote:
We're getting a very bad idle with the Zetec in Carole's 2+2. With the idle
speed control valve connected from cold it will idle nicely at around
1000rpm, if just left to idle and warm through. However if you rev, or
drive that car the best idle to can get is between 2-3,000 rpm, which isn't
great :( The car also drives badly, having hesitation and then you fight
the engine on the over run.
It is a lot better with the ISCV disconnected, but still not great. The
idle is still a bit high, being around 1,200 rpm and it still doesn't drive
that great.
We've tried resetting the ECU to re-program it and Geoff's cleaned all the
electrical contact and the ISCV. Any ideas what else needs to be done to
get this ready before the HHII?
Regards,
Steve
--
www.h4-turbo.co.uk
www.quantumowners.co.uk
www.quantumcars.co.uk
www.quantumheritage.co.uk
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).