The power steering switch makes a very small difference to the RPM, it
won't be causing your problem, or the road speed sensor, it doesn't make
that much difference.
The throttle pot maybe.
The reason i asked about the throttle stop is when my Mondeo was messing
about at idle because it had fast road cams in it, i tried increasing
the idle speed by adjusting the throttle stop on the throttle body
(which everything warns you not to do).
The effect i got then was a faster idle when you started it but as soon
as you pressed the throttle the idle jumped up to 2000 rpm and stayed
there, if you pressed the throttle again is jumped up to 2500 rpm.
The ecu was obviously getting very confused.
So i put it back where it was.
Has the loom got the OBD2 diagnostics connector ?
Jim
On 01/06/2010 13:33, Steve Kodz wrote:
We can check the other faults, but reading the links Gary sent sound
promising too.
The talk about the power steering switch needing to be a closed circuit is
useful as that'll drop the revs by 100rpm. The most likely source could be
the Throttle Position Sensor (TPS) as this has caused similar faults on
these forums, but it doesn't explain why disconnecting the ISCV improves
things.
Geoff will also have to make sure that the vehicle speed sensor has clean
contacts.
How do you read faults on these ECUs, as they have a large connector that is
the interface and I assume that's where you get the fault code from.
Regards,
Steve
--
www.h4-turbo.co.uk
www.quantumowners.co.uk
www.quantumcars.co.uk
www.quantumheritage.co.uk
On Tuesday 01 Jun 2010, Jim Hearne wrote:
Sorry, have you checked for fault codes ?
Jim
On 01/06/2010 12:29, Steve Kodz wrote:
We're getting a very bad idle with the Zetec in Carole's 2+2. With the
idle speed control valve connected from cold it will idle nicely at
around 1000rpm, if just left to idle and warm through. However if you
rev, or drive that car the best idle to can get is between 2-3,000
rpm, which isn't great :( The car also drives badly, having
hesitation and then you fight the engine on the over run.
It is a lot better with the ISCV disconnected, but still not great.
The idle is still a bit high, being around 1,200 rpm and it still
doesn't drive that great.
We've tried resetting the ECU to re-program it and Geoff's cleaned all
the electrical contact and the ISCV. Any ideas what else needs to be
done to get this ready before the HHII?
Regards,
Steve
--
www.h4-turbo.co.uk
www.quantumowners.co.uk
www.quantumcars.co.uk
www.quantumheritage.co.uk
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).