Yes, we pulled the injector rail off the plastic inlet and used those, 
rather than the ones that came with the alloy inlet.  We also swapped over 
the TPS and throttle body from the original car, to ensure we have matching 
parts.  The only part we couldn't transfer over was the ISCV, as these are 
very different between the 2 inlets.

Geoff can confirm, but all the gaskets had red gasket compound used when 
reassembled, but the leak test might be worth trying, although as it will 
idle nicely from start up until the throttle is pressed would probably tend 
to discount this.

Regards,
Steve
--
www.h4-turbo.co.uk
www.quantumowners.co.uk
www.quantumcars.co.uk
www.quantumheritage.co.uk

On Tuesday 01 Jun 2010, Jim Hearne wrote:
> Try unplugging the AFM
> 
> Are all the injection parts off the same engine as the ecu ?, AFM,
> injectors, inlet manifold, throttle body etc ?
> 
> Has the throttle body been removed ?, was the gasket under it the
> correct type (Black plastic and metal inlet manifolds use different
> gaskets.
> 
> Are you sure theres not a air leak somewhere, play a hose around the
> inlet manifold and throttle body, if the engine note suddenly changes
> the water has been sucked into a gap and blocked it momentarily.
> 
> Jim
> 
> On 01/06/2010 12:29, Steve Kodz wrote:
> > We're getting a very bad idle with the Zetec in Carole's 2+2.  With the
> > idle speed control valve connected from cold it will idle nicely at
> > around 1000rpm, if just left to idle and warm through.  However if you
> > rev, or drive that car the best idle to can get is between 2-3,000
> > rpm, which isn't great :(  The car also drives badly, having
> > hesitation and then you fight the engine on the over run.
> > 
> > It is a lot better with the ISCV disconnected, but still not great. 
> > The idle is still a bit high, being around 1,200 rpm and it still
> > doesn't drive that great.
> > 
> > We've tried resetting the ECU to re-program it and Geoff's cleaned all
> > the electrical contact and the ISCV.  Any ideas what else needs to be
> > done to get this ready before the HHII?
> > 
> > Regards,
> > Steve
> > --
> > www.h4-turbo.co.uk
> > www.quantumowners.co.uk
> > www.quantumcars.co.uk
> > www.quantumheritage.co.uk

-- 
You received this message because you are subscribed to the Google Groups 
"Quantum Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to 
[email protected]
For more options, visit this group at 
http://groups.google.com/group/quantumowners?hl=en

IMPORTANT NOTE: All information presented herewith is provided on an "As Is" 
basis, without warranty or the implication thereof. Neither the Quantum Owners 
Club nor the individuals associated with the Quantum Owners Club or in the 
preparation of the above information shall have any liability to any person or 
entity with respect to liability, loss, or damage caused or alleged to be 
caused directly or indirectly by the instructions contained within this or 
related message(s).

Reply via email to