Should all be ok then.
The idle valve is fine, i've always used the alloy one.
Could be the throttle pot as mentioned in that article, especially if
you removed the TPS from the throttle body.
Make sure the throttle cable isn't sticking and is allowing the linkage
to come back fully against the stop, otherwise it would have the same
effect.
Jim
On 01/06/2010 13:39, Steve Kodz wrote:
Yes, we pulled the injector rail off the plastic inlet and used those,
rather than the ones that came with the alloy inlet. We also swapped over
the TPS and throttle body from the original car, to ensure we have matching
parts. The only part we couldn't transfer over was the ISCV, as these are
very different between the 2 inlets.
Geoff can confirm, but all the gaskets had red gasket compound used when
reassembled, but the leak test might be worth trying, although as it will
idle nicely from start up until the throttle is pressed would probably tend
to discount this.
Regards,
Steve
--
www.h4-turbo.co.uk
www.quantumowners.co.uk
www.quantumcars.co.uk
www.quantumheritage.co.uk
On Tuesday 01 Jun 2010, Jim Hearne wrote:
Try unplugging the AFM
Are all the injection parts off the same engine as the ecu ?, AFM,
injectors, inlet manifold, throttle body etc ?
Has the throttle body been removed ?, was the gasket under it the
correct type (Black plastic and metal inlet manifolds use different
gaskets.
Are you sure theres not a air leak somewhere, play a hose around the
inlet manifold and throttle body, if the engine note suddenly changes
the water has been sucked into a gap and blocked it momentarily.
Jim
On 01/06/2010 12:29, Steve Kodz wrote:
We're getting a very bad idle with the Zetec in Carole's 2+2. With the
idle speed control valve connected from cold it will idle nicely at
around 1000rpm, if just left to idle and warm through. However if you
rev, or drive that car the best idle to can get is between 2-3,000
rpm, which isn't great :( The car also drives badly, having
hesitation and then you fight the engine on the over run.
It is a lot better with the ISCV disconnected, but still not great.
The idle is still a bit high, being around 1,200 rpm and it still
doesn't drive that great.
We've tried resetting the ECU to re-program it and Geoff's cleaned all
the electrical contact and the ISCV. Any ideas what else needs to be
done to get this ready before the HHII?
Regards,
Steve
--
www.h4-turbo.co.uk
www.quantumowners.co.uk
www.quantumcars.co.uk
www.quantumheritage.co.uk
--
You received this message because you are subscribed to the Google Groups "Quantum
Owners Group" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to
[email protected]
For more options, visit this group at
http://groups.google.com/group/quantumowners?hl=en
IMPORTANT NOTE: All information presented herewith is provided on an "As Is"
basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor
the individuals associated with the Quantum Owners Club or in the preparation of the
above information shall have any liability to any person or entity with respect to
liability, loss, or damage caused or alleged to be caused directly or indirectly by the
instructions contained within this or related message(s).