Decision made, going to use the boss behind the one indicated on Jim's photo. Plan is to take the sump off, jig and drill it at work to 19mm and tap for a 1/2 BSP union, it will be close on wall thickness for the boss, but is just about achieveable. On the photo shown; was that drilled out for a push in connector? Next question is what internal diameter does the return bore need to be? I was planning on abouit 13mm, but some sites indicate 15mm, which is hard to achieve unless I make a hybrid push in connector, what have you guys used?
Nigel -- You received this message because you are subscribed to the Google Groups "Quantum Owners Group" group. To post to this group, send email to [email protected] To unsubscribe from this group, send email to [email protected] For more options, visit this group at http://groups.google.com/group/quantumowners?hl=en IMPORTANT NOTE: All information presented herewith is provided on an "As Is" basis, without warranty or the implication thereof. Neither the Quantum Owners Club nor the individuals associated with the Quantum Owners Club or in the preparation of the above information shall have any liability to any person or entity with respect to liability, loss, or damage caused or alleged to be caused directly or indirectly by the instructions contained within this or related message(s).
