On Wed, 2010-11-17 at 11:07 -0800, William wrote: > With your updated report you've ruled out cable and housing friction, > and in my opinion have eliminated re-routing the cable/housing as a > possible solution. If it were friction related, you'd shift well in > the 'pulling the cable directio' and poorly in the 'releasing the > cable direction' over all 9 cogs. Since you have problems in BOTH > directions on the bad cogs and it works in both directions on the good > cogs, and since you can adjust any 2 or 3 cogs to be good, but that > makes all the other ones bad, then this is absolutely a cable pull > rate problem. Your derailleur is moving too far, or not far enough > per click. That means you either have a combination of parts that > don't work together, or you've attached the cable to the derailer > incorrectly. If you run the cable on the wrong side of the anchor > bolt, you change the effective shape of the linkage and the pull rates > change. Some people creatively route the cable wrong to get a Shimano > this to click correctly with a Campy that. On a Shimano Deore XT Low- > normal rear derailer (both the current one without the adjusting > barrel or the last one that had an adjusting barrel built in), the > cable should be routed on the outside of the anchor bolt, on the near > side closer to you when you face the derailer. This is the opposite > side to what you are used to if you normally set up non-rapid-rise, > non-low-normal rear derailers. The photo of the XT low normal rear > derailer on the Riv-site has it routed correctly: > > http://www.rivbike.com/products/show/shimano-xt-rear-der/17-117 > > Check that first. Take a picture of it, so we can see that it is > right.
I was just looking at Sheldon's Dura Ace compatibility chart (http://www.sheldonbrown.com/dura-ace.html) and it made mention of a 10 spd Shadow MTB rear derailleur that is compatible only with a 10 speed Shadow shifter. Is there any chance this could be one of those? -- You received this message because you are subscribed to the Google Groups "RBW Owners Bunch" group. To post to this group, send email to rbw-owners-bu...@googlegroups.com. To unsubscribe from this group, send email to rbw-owners-bunch+unsubscr...@googlegroups.com. For more options, visit this group at http://groups.google.com/group/rbw-owners-bunch?hl=en.