Hello all,I have written a short introductory article on reverberation chambers
for a local EMC magazine here in Australia.This is enclosed for anybody who has
similar interests.Thanks
Arun Kaore
arun_ka...@yahoo.com
-
Do You Yahoo!?
Yahoo! Auctions - Click
to
CISPR 12.
Your could try to come and visit us at our lab in St Marys, NSW while we
test a lot of commercial and military stuff, apart from development work on
reverberation chambers. Unfortunately, we cannot release procedures as they
are proprietary.
Regards
Arun Kaore
ADI Limited
, MIL STD 461D and most commercial standards
have got around this NB/BB emission discrimination mess by specifying the
measurement BW.
Hope this helps.
Regards
Arun Kaore
EMC Engineer
ADI Limited
Test
only.
A zoomed in measurement from 3m to 1m to beat the noise floor is not
recommended as the antenna and EUT dimensions become critical.
Hope this helps
Regards
Arun Kaore
EMC Engineer
ADI Limited
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O Box: 315, St Marys NSW 1790
Tel
where one forgets about the use of LISNs and
shudders at the thought of using a HV probe.
Cost of such stringent EMC testing will almost inevitably be built into the
contract.
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O
.
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Email: kao...@sg.adi-limited.com.au mailto:kao...@sg.adi-limited.com.au
-
This message is coming from
/462 CS06 (in air!!), or
CS115/CS116/ RS02 pre compliance.
I cannot comment on your Fire Alarm system though, but I would hazard a
guess and attribute it to HCP or capacitive coupling via unshielded cables
spaced off the metal test sheet (the GRP).
Regards
Arun Kaore
EMC Engineer
ADI Limited
types).
And we did not have to do any fancy design, just followed the Application
Note at the back of the Catalogue. Thermals were a bit of a problem though.
Microlinear have (and this goes back to 1992) some prototyping kits too.
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test
/ anechoic
chamber will make you very popular among your colleagues because of the
additional filtering within the shielded room.
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax
Hello all
I am overwhelmed with the help I got from you all, this short note is to
express my thanks !!
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Hi all,
Could someone guide me on where to down load from the net or purchase the
latest version of MIL-HDBK-217 and approximately how much it would cost. It
is a Reliability/MTBF related issue.
Thanks in advance.
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation
, at the end of the day, just because the site attenuation of any
site is accurate, this does not mean that the measurement uncertainity has
come down or that the EMC tests that are carried out on the site are equally
accurate (nothing to do with the lab or personnel!!)
.
Regards
Arun Kaore
EMC
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Email: kao...@sg.adi-limited.com.au mailto:kao...@sg.adi-limited.com.au
-Original Message-
From: VENTER
in at a reduced
bandwidth (lower than 120kHz, for better resolution) if necessary.
Why don't you repeat your 30MHz NSA at 10 metres?
Regards
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax
is applied 5 cm away from the outer
shell near the yoke coil.
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Email: kao...@sg.adi-limited.com.au mailto:kao...@sg.adi
of oxides on an otherwise perfect
bond in salty, humid or corrosive atmosphere rendering shielding
effectiveness failure over time and/or environment, bringing up issues of
periodic EMI/EMC Preventive Maintainence in the log books!
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation
the Automotive Directive.
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Email: kao...@sg.adi-limited.com.au
From: PETER PHILLIPS [mailto:peter.phill...@mira.co.uk]
mailto
sheet temperature, for which the manufacturer has
provided the life data. ( Also known as accelerated life test). Related info
in MIL-STD-105.
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
mathematical boresighting and you get
a better vertical result.
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Email: kao...@sg.adi-limited.com.au
-Original
(keeping pace with what would
generally be expected in the industry) notwithstanding what EN55024
stipulates.
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys, NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673 8321
Email
not be the premier line of defence against
voltage stress breakdowns when reduced creepages/ clearances are delibrately
designed in.
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys, NSW 2760
P O Box: 315, St Marys NSW 1790
Tel: 61 2 9673 8375
Fax: 61 2 9673
the golden 120*pi rule and make the conversion. But, is this what is
expected of a test house?
Also, ITE frequencies have shot past 500MHz, is an equivalent CISPR 22
frequency upgrade in the pipeline?
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test Evaluation Centre
Forrester Road, St Marys
This site is maintained by Standards Australia
www.aca.gov.au
Email: s...@aca.gov.au
This site is maintained by Australian Communications Authority (something
like the FCC)
For military testing: 461C or D is generally used.
Hope this helps
Arun Kaore
EMC Engineer
ADI Limited
Systems Group
Test
23 matches
Mail list logo