> -Original Message-
> From: Mike Reagan [mailto:[EMAIL PROTECTED]]
> Sent: Sunday, December 01, 2002 2:54 PM
> To: Protel EDA Forum
> Subject: Re: [PEDA] Simple (?) Pasting Problem
>
> Brian wrote,
>
> > I've seen this before with a component which has
Actually, Brian, Mike,
The problem is Prohell ; )
And it is just operating normally ; )
JaMi
- Original Message -
From: "Mike Reagan" <[EMAIL PROTECTED]>
To: "Protel EDA Forum" <[EMAIL PROTECTED]>
Sent: Sunday, December 01, 2002 6:53 AM
Subject: Re: [
Brian wrote,
> I've seen this before with a component which has only "1" contact, just
like a test point.
>
Hi Brian,
I have seen some similar problems with fiducials. My fiducials patterns
contain a keep out circle around the soldermask. When I select outside of a
board area, the fiducials
IL PROTECTED]>
Sent: Wednesday, November 27, 2002 8:39 PM
Subject: Re: [PEDA] Simple (?) Pasting Problem
> In addition - Upon further investigation, it appears that it only happens on
> certain library components. I tried it on a testpoint of ours - crash. I
> then tri
n library) - it
> works... *sob*
> ;)
>
> -Original Message-
> From: Terry Creer
> Sent: Thursday, 28 November 2002 12:05 PM
> To: Protel EDA Forum (E-mail)
> Subject: [PEDA] Simple (?) Pasting Problem
>
>
> AAGHH!!!
>
> All of a sudden, I've discovered
the same.
Igor
-Original Message-
From: Terry Creer [mailto:[EMAIL PROTECTED]]
Sent: Thursday, 28 November 2002 12:40 PM
To: 'Protel EDA Forum'
Subject: Re: [PEDA] Simple (?) Pasting Problem
In addition - Upon further investigation, it appears that it only happens on
certa
t; works... *sob*
> ;)
>
> -Original Message-
> From: Terry Creer
> Sent: Thursday, 28 November 2002 12:05 PM
> To: Protel EDA Forum (E-mail)
> Subject: [PEDA] Simple (?) Pasting Problem
>
>
> AAGHH!!!
>
> All of a sudden, I've discovered that
i doubt it is W2K
i have seen it on a few occasions
it went away somehow
are you pasting into the same document as cutting/copying?
when i cut/copy from one doc into another i have learned not to close
the first one until later, after the paste
i think they improved this somewhere along the way to
Subject: [PEDA] Simple (?) Pasting Problem
>
>
> AAGHH!!!
>
> All of a sudden, I've discovered that if I select a single
> component and
> then either Cut or Copy it, and then paste it (or paste an
> array of them),
> Protel (99SE sp6) locks up completely an
November 2002 12:05 PM
To: Protel EDA Forum (E-mail)
Subject: [PEDA] Simple (?) Pasting Problem
AAGHH!!!
All of a sudden, I've discovered that if I select a single component and
then either Cut or Copy it, and then paste it (or paste an array of them),
Protel (99SE sp6) locks up completel
AAGHH!!!
All of a sudden, I've discovered that if I select a single component and
then either Cut or Copy it, and then paste it (or paste an array of them),
Protel (99SE sp6) locks up completely and the status bar just says
'processing pasted primitives'.
This is not repeatable on the
11 matches
Mail list logo