>Umm...it was designed on a B14 so that might be the problem. But, I was
>helping a guy install his who got it through the group deal, and there were
>crazy fitment issues. I had to grind off part of the fittings for the
>hoses
>to make those fit. All in all, a pain in the ass, but then again, you run
>into these problems with all cold air intakes.
VERY TRUE! I have the PR CAI and there was a lot of "fabricating" needed to
install it correctly. For instance, I had to weld a bracket on the lower
pipe to make sure it didnt shift around. Then I had to replace all the
hoses and buy a 90 degree elbow for one of them dont remember which one so
it wouldnt collapse. Very soon im going to make a gasket for the maf and
adapter plate because its just plastic against metal and i dont think its
sealed very well. Dont get me wrong, its a good piece, but now that i think
about it, $200 is a little pricey.
Javier
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
+----------------------------------------------------------------------+
List archives ==> http://www.escribe.com/automotive/sml
Have a question? Try the archives first.
