Re: ShopTalk: removing driver head

[Carl McKinley]

Paul,

 

Then if you have a drill and the correct sized bit you're all set. Simply drill out the broken shaft,

prep the new shaft and hosel, glue and go.

 

Carl

Paul Strand <[EMAIL PROTECTED]> wrote:

I have only a vise and butane "torch". The shaft is already broken so the
only part I'm interested in saving is the club head. I will stipulate to
being under equipped.

Thanks

Paul Strand
----- Original Message -----
From: "Carl McKinley" <[EMAIL PROTECTED]>
To:
Sent: Thursday, July 28, 2005 6:38 AM
Subject: Re: ShopTalk: removing driver head


> Paul,
>
> To remove a graphite shaft you should be using a
> shaft puller. If you are trying to pull the head
> by heating and then twisting the head off you
> will in all likelyhood damage the shaft.
>
> Carl
>
> --- Paul Strand <[EMAIL PROTECTED]>wrote:
>
> > I've been asked to remove and reshaft a Taylor
> > Made 360 Ti driver with a UST 65 350 shaft.
> > Have heated th! e club head to point where
> > ferrule has softened and there is play in the
> > hosel but I'm not able to pull the shaft with
> > the usual hand pressure. Is there something
> > I'm missing like it being pinned, etc?
> >
> > TIA
> >
> > Paul Strand
>
>
> Carl Mc Kinley Retired,
> PCS Certified Class 'A' Clubmaker (Life Member)
> GCA Accredited Clubbuilder
> [EMAIL PROTECTED]
>
> P T Barnum is the patron saint of expensive club manufacturers.
>
>
>
> ____________________________________________________
> Start your day with Yahoo! - make it your home page
> http://www.yahoo.com/r/hs
>

---

Start your day with Yahoo! - make it your home page