>I finally have the results from the kimball labs. Below are the results. >Device used is 3 nine volts batters, distilled water with ppm reading of >1ppm,water heated to 180 degrees then transfered to a hotplate. Total run >time was 2 1/2 hours with 3 cups of Distilled water. >TDS 1 meter kimball >March 31 1998 >23ppm 32.9ppm (tested on 4/2 >It looks like a difference of +10ppm >I will use this for future reference when making my CS. >I did notice though that after I measure out a dosage of CS and then test, >it reads at a lower ppm. Anyone know why? Sometimes it also reads lower a >few days later. >Donna Earnest
This is just a guess but I can see two reasons. Glass is a static negitive so charged particals will attract. So pooring from one to another will cause particals to attract to the sides of the glass. The other reason is the discharging of particals. When a positive and a negitive come in concat they nutralize theirself. Give this trick a try and see what happens. Rinse the glass that your going to poor the CS into first with distilled water TWICE not once. Poor it in and check. Another thing to try, poor into an empty glass some CS, measure it then poor it out. Poor in the same glass that you just emptyed and test it again. It should increase the PPM with the second poor. Take Care Reid -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
