Donna, Do you measure while the water is still warm? Then later it is cold? Do you store your silver in darkness? In what? Do you ever notice any of what I call "fallout", the powder at the bottom of the container? Just some thoughts....
Also, what are you using to hold 3 c of distilled water on a hotplate? I plan to make one of these for my sister and would like to make one now in order to take with me (already tested)in May to Mass. I am impressed that 3 nine volt batteries can give such a high ppm reading. That's just what I want. Now another thought/question. Is the storage capability maybe what some of the discussion re. high vs low voltage and ac/dc discussion might be about? Is there any reason one would store better than the other? Thanks for sharing. Liz ==================================================================== > I finally have the results from the kimball labs. Below are the results. > Device used is 3 nine volts batters, distilled water with ppm reading of > 1ppm,water heated to 180 degrees then transfered to a hotplate. Total run > time was 2 1/2 hours with 3 cups of Distilled water. > TDS 1 meter kimball > March 31 1998 > 23ppm 32.9ppm (tested on 4/2 > It looks like a difference of +10ppm > I will use this for future reference when making my CS. > I did notice though that after I measure out a dosage of CS and then test, > it reads at a lower ppm. Anyone know why? Sometimes it also reads lower a > few days later. > Donna Earnest > > > -- > The silver-list is a moderated forum for discussion of colloidal silver. > > To join or quit silver-list or silver-digest send an e-mail message to: > [email protected] -or- [email protected] > with the word subscribe or unsubscribe in the subject: line. > > To post, address your message to: [email protected] > > List maintainer: Mike Devour <[email protected]> > > -- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
