I finally have the results from the kimball labs. Below are the results. Device used is 3 nine volts batters, distilled water with ppm reading of 1ppm,water heated to 180 degrees then transfered to a hotplate. Total run time was 2 1/2 hours with 3 cups of Distilled water. TDS 1 meter kimball March 31 1998 23ppm 32.9ppm (tested on 4/2 It looks like a difference of +10ppm I will use this for future reference when making my CS. I did notice though that after I measure out a dosage of CS and then test, it reads at a lower ppm. Anyone know why? Sometimes it also reads lower a few days later. Donna Earnest
-- The silver-list is a moderated forum for discussion of colloidal silver. To join or quit silver-list or silver-digest send an e-mail message to: [email protected] -or- [email protected] with the word subscribe or unsubscribe in the subject: line. To post, address your message to: [email protected] List maintainer: Mike Devour <[email protected]>
