Tom are you telling us that the frequencies are not correct in version 2.4? 73
On Fri, Jun 6, 2008 at 1:57 PM, Tom Hoflich <[EMAIL PROTECTED]> wrote: > Yes, 1111 is at hex 60. > > There has been a list of frequencies and offsets for 2.4 and 2.5 for a > while in the XTALL daughter board folder called XTALL frequency lists.xls > > > > You do have to work a little to get the 2.4 offsets, however. > > > > 73, Tom KM5H > > > > --- On *Thu, 6/5/08, dick_faust <[EMAIL PROTECTED]>* wrote: > > From: dick_faust <[EMAIL PROTECTED]> > Subject: [softrock40] Re: Xtall Software V2.4 - SI570 Registers? > To: [email protected] > Date: Thursday, June 5, 2008, 8:07 PM > > Tom, > Thanks for the clearifications. > > Location 0 in the eeprom is the 6 registers that are read from the > Si570 > > Location 6 in the eeprom is the 6 registers for switch setting 0000. > > Location C hex is the 6 registers for switch setting 0001 and so on. > > > Does the last location [switch setting #15 {1111}] start at 0x60 ? Just > a check on my math. > > Is there a place to change the I2C address ? > > I will still make a spreadsheet for the memory map for v2.4 so each > location is clear. Could make one for v2.4+ too if it is just a shift > of 6 places. > > Thanks, > 73, Dick K9IVB > > > -- Jose Bonanca (CT1aos)
