>The extra messages may be in your system logs. Have a look in
>/var/log/messages or /var/log/syslog to see if any turned up.
>
>Ciao,
>
>D.
oh i see...
this is what i get then..
Jun 29 12:40:29 xxxxx-yyyy syslogd 1.4.1: restart.
Jun 29 12:40:32 xxxxx-yyyy ifstatus: lo
Jun 29 12:40:32 xxxxx-yyyy ifstatus: lo is up
Jun 29 12:40:32 xxxxx-yyyy ifstatus: 1: lo: <LOOPBACK,UP> mtu 16436 qdisc
noqueue
Jun 29 12:40:32 xxxxx-yyyy ifstatus: link/loopback 00:00:00:00:00:00
brd 00:00:00:00:00:00
Jun 29 12:40:32 xxxxx-yyyy ifstatus: inet 127.0.0.1/8 scope host lo
Jun 29 12:40:32 xxxxx-yyyy ifstatus: IP address: 127.0.0.1/8
Jun 29 12:40:33 xxxxx-yyyy kernel: klogd 1.4.1, log source = /proc/kmsg
started.
Jun 29 12:40:33 xxxxx-yyyy kernel: atm: module not supported by Novell,
setting U taint flag.
Jun 29 12:40:33 xxxxx-yyyy kernel: NET: Registered protocol family 8
Jun 29 12:40:33 xxxxx-yyyy kernel: NET: Registered protocol family 20
Jun 29 12:40:33 xxxxx-yyyy kernel: CSLIP: code copyright 1989 Regents of
the University of California
Jun 29 12:40:33 xxxxx-yyyy kernel: PPP generic driver version 2.4.2
Jun 29 12:40:33 xxxxx-yyyy kernel: pppoatm: module not supported by Novell,
setting U taint flag.
Jun 29 12:40:34 xxxxx-yyyy kernel: BIOS EDD facility v0.16 2004-Jun-25, 2
devices found
Jun 29 12:40:34 xxxxx-yyyy ifstatus-route: Configured routes for interface lo:
Jun 29 12:40:34 xxxxx-yyyy ifstatus-route: 127/8 - - lo
Jun 29 12:40:35 xxxxx-yyyy ifstatus-route: Active routes for interface lo:
Jun 29 12:40:35 xxxxx-yyyy ifstatus-route: 127.0.0.0/8 scope link
Jun 29 12:40:35 xxxxx-yyyy ifstatus-route: 1 of 1 configured routes for
interface lo up
Jun 29 12:40:38 xxxxx-yyyy ifup: lo
Jun 29 12:40:38 xxxxx-yyyy ifup: lo
Jun 29 12:40:38 xxxxx-yyyy ifup: IP address: 127.0.0.1/8
Jun 29 12:40:38 xxxxx-yyyy ifup:
Jun 29 12:40:43 xxxxx-yyyy ifup: eth0 device: VIA Technologies,
Inc. VT6105 [Rhine-III] (rev 86)
Jun 29 12:40:43 xxxxx-yyyy ifup: eth0 configuration:
eth-id-00:50:fc:c9:9a:fe
Jun 29 12:40:43 xxxxx-yyyy kernel: eth0: link up, 100Mbps, full-duplex, lpa
0x45E1
Jun 29 12:40:43 xxxxx-yyyy ifup: eth0
Jun 29 12:40:43 xxxxx-yyyy ifup: IP address: aaa.bbb.0.xxx/24
Jun 29 12:40:43 xxxxx-yyyy ifup:
Jun 29 12:40:44 xxxxx-yyyy ifup: ppp0
Jun 29 12:40:44 xxxxx-yyyy ifup: ppp0 Startmode is 'manual'
Jun 29 12:40:45 xxxxx-yyyy mDNSResponder (Engineering Build) (Apr 23 2006
01:49:36) [2968]: starting
Jun 29 12:40:45 xxxxx-yyyy mDNSResponder: Unable to parse DNS server list.
Unicast DNS-SD unavailable
Jun 29 12:40:48 xxxxx-yyyy kernel: NET: Registered protocol family 10
Jun 29 12:40:48 xxxxx-yyyy kernel: lo: Disabled Privacy Extensions
Jun 29 12:40:48 xxxxx-yyyy kernel: IPv6 over IPv4 tunneling driver
Jun 29 12:40:48 xxxxx-yyyy sshd[3110]: Server listening on :: port 22.
Jun 29 12:40:49 xxxxx-yyyy ifup: sit0
Jun 29 12:40:49 xxxxx-yyyy ifup: No configuration found for sit0
Jun 29 12:40:50 xxxxx-yyyy auditd[3200]: Init complete, auditd 1.1.3
listening for events
Jun 29 12:40:52 xxxxx-yyyy kernel: powernow: This module only works with
AMD K7 CPUs
Jun 29 12:40:54 xxxxx-yyyy rcpowersaved: CPU frequency scaling is not
supported by your processor.
Jun 29 12:40:54 xxxxx-yyyy rcpowersaved: enter 'CPUFREQ_ENABLED=no' in
/etc/powersave/cpufreq to avoid this warning.
Jun 29 12:40:54 xxxxx-yyyy rcpowersaved: Cannot load cpufreq governors - No
cpufreq driver available
Jun 29 12:40:55 xxxxx-yyyy rcpowersaved: s2ram does not know your machine.
See 's2ram -i' for details. (127)
Jun 29 12:40:55 xxxxx-yyyy rcpowersaved: Use SUSPEND2RAM_FORCE=yes to
override this detection.
Jun 29 12:40:56 xxxxx-yyyy [powersave]: WARNING (readConfigFile:183) Found
actions variable for non existing event: 'global.suspend'
Jun 29 12:40:56 xxxxx-yyyy [powersave]: WARNING (readConfigFile:183) Found
actions variable for non existing event: 'global.resume.suspend'
Jun 29 12:40:58 xxxxx-yyyy kernel: eth0: no IPv6 routers present
Jun 29 12:40:58 xxxxx-yyyy [powersave-set_disk_settings][3310]: WARNING:
hdparm returned error '5'
Jun 29 12:40:58 xxxxx-yyyy kernel: hdb: drive_cmd: status=0x51 { DriveReady
SeekComplete Error }
Jun 29 12:40:58 xxxxx-yyyy kernel: hdb: drive_cmd: error=0x04 {
DriveStatusError }
Jun 29 12:40:58 xxxxx-yyyy kernel: ide: failed opcode was: 0xef
Jun 29 12:41:00 xxxxx-yyyy /usr/sbin/cron[3401]: (CRON) STARTUP (V5.0)
Jun 29 12:41:01 xxxxx-yyyy smpppd[3412]: smpppd version 1.59 started
Jun 29 12:41:02 xxxxx-yyyy smbd[3316]: [2006/06/29 12:41:02, 0]
printing/print_cups.c:cups_cache_reload(85)
Jun 29 12:41:02 xxxxx-yyyy smbd[3316]: Unable to connect to CUPS server
localhost - Connection refused
Jun 29 12:41:02 xxxxx-yyyy smbd[3316]: [2006/06/29 12:41:02, 0]
printing/print_cups.c:cups_cache_reload(85)
Jun 29 12:41:02 xxxxx-yyyy smbd[3316]: Unable to connect to CUPS server
localhost - Connection refused
Jun 29 12:41:07 xxxxx-yyyy webmin[3425]: Webmin starting
Jun 29 12:41:08 xxxxx-yyyy zmd: NetworkManagerModule (WARN): Failed to
connect to NetworkManager
Jun 29 12:41:15 xxxxx-yyyy PAM-devperm[3228]: opendir(/dev/snd/*): No such
file or directory
Jun 29 12:41:15 xxxxx-yyyy kernel: ip6_tables: (C) 2000-2006 Netfilter Core
Team
Jun 29 12:41:15 xxxxx-yyyy SuSEfirewall2: Warning: ip6tables does not
support state matching. Extended IPv6 support disabled.
Jun 29 12:41:16 xxxxx-yyyy SuSEfirewall2: Setting up rules from
/etc/sysconfig/SuSEfirewall2 ...
Jun 29 12:41:16 xxxxx-yyyy SuSEfirewall2: Warning: no interface active
Jun 29 12:41:16 xxxxx-yyyy kernel: ip_tables: (C) 2000-2006 Netfilter Core Team
Jun 29 12:41:16 xxxxx-yyyy kernel: Netfilter messages via NETLINK v0.30.
Jun 29 12:41:17 xxxxx-yyyy kernel: ip_conntrack version 2.4 (1015 buckets,
8120 max) - 232 bytes per conntrack
Jun 29 12:41:18 xxxxx-yyyy SuSEfirewall2: Warning:
FW_ALLOW_INCOMING_HIGHPORTS_UDP=DNS is no longer supported
Jun 29 12:41:18 xxxxx-yyyy SuSEfirewall2: batch committing...
Jun 29 12:41:22 xxxxx-yyyy SuSEfirewall2: Firewall rules successfully set
Jun 29 12:41:25 xxxxx-yyyy zmd: Daemon (WARN): Not starting remote web server
Jun 29 12:41:52 xxxxx-yyyy kernel: SFW2-IN-ILL-TARGET IN=eth0 OUT= MAC=
SRC=192.168.0.133 DST=224.0.0.251 LEN=112 TOS=0x00 PREC=0x00 TTL=255 ID=0
DF PROTO=UDP SPT=5353 DPT=5353 LEN=92
Jun 29 12:41:55 xxxxx-yyyy hp: unable to open /var/run/hpiod.port: No such
file or directory: prnt/hpijs/hplip_api.c 84
Jun 29 12:45:39 xxxxx-yyyy su: (to beagleindex) root on none
Jun 29 12:52:48 xxxxx-yyyy shutdown[4098]: shutting down for system halt
Jun 29 12:52:50 xxxxx-yyyy init: Switching to runlevel: 0
Jun 29 12:52:54 xxxxx-yyyy auditd[3200]: The audit daemon is exiting.
Jun 29 12:52:55 xxxxx-yyyy kernel: audit(1151578374.912:6): audit_pid=0
old=3200 by auid=4294967295
Jun 29 12:53:00 xxxxx-yyyy zmd: ShutdownManager (WARN): Preparing to shut
down...
Jun 29 12:53:05 xxxxx-yyyy smpppd[3429]: terminating on signal 15
Jun 29 12:53:08 xxxxx-yyyy sshd[3110]: Received signal 15; terminating.
Jun 29 12:53:10 xxxxx-yyyy kernel: Kernel logging (proc) stopped.
Jun 29 12:53:10 xxxxx-yyyy kernel: Kernel log daemon terminating.
Jun 29 12:53:12 xxxxx-yyyy exiting on signal 15
___________________________________________________________
Gesendet von Yahoo! Mail - Jetzt mit 1GB Speicher kostenlos - Hier anmelden:
http://mail.yahoo.de
Liste de diffusion modem ALCATEL SpeedTouch USB
Pour se désinscrire : mailto:[EMAIL PROTECTED]
