on 04.08.2004 09:35, Diane Beach at [EMAIL PROTECTED] wrote: > Hi > Here's an update to the question I asked the other day, my original question > had incorrect information. The riser card I referred to below stays with the > Powercurve. My new question is with system 9.1 on a Umax J700 which software > do I download from the site below? > > http://eshop.macsales.com/tech_center/index.cfm?page=accelerators_newertech.ht > ml&title=Accelerators > > I downloaded some of it, but there is so much there I must not have the > correct software as the G3 card will not work. When the card is in, the > system starts up I get the happy mac and then it just sits there in that > mode without loading any extensions at the bottom, acts frozen. I also tried > zapping the PRAM so is there any other reason the card would not work, any > ideas would be greatly appreciated.
Hi Diane, Did you reset the CUDA? This is the driver you need: <http://eshop.macsales.com/Tech/FTP/newertech/MAXpowr205Installer.hqx> HTH, paul -- Paul F. Henegan <[EMAIL PROTECTED]> -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
