On Wed, 11 Aug 1999 14:57:45 -0700, Jerry J. Haumberger wrote:
> I see. If I had such an initializer program, would I have to use
> it with a separate MENU statement configuration under PC DOS
> without SB's drivers loaded?
It should be loaded _before_ Creativelabs' SB Pro drivers.
It's treated like a low level driver, only not resident.
> So Creative Labs seems to have what's necessary for DOS development?
Not really. The answer is yes, as long as the compatible sound
card already set to full SB support, so the drivers "tricked" to
see the card as "the real" Sound Blaster. Unfortunately, the
spec required to initialize such "multimode" sound card usually
differs for each chipset maker/brand. In your case, Yamaha
electronics have it...
Hey, perhaps those SB drivers conflicting with Blaster Master?
How about REM-ing those drivers from your CONFIG.SYS? Could
Blaster Master detect your card that way? I just remember that
CT*.SYS drivers only required by Creativelabs apps. Try REM
your "BLASTER" parms as well, this will force Blaster Master
to scan all possible SB port/IRQ/DMA. Good luck! :)
--
Eko Priono - mailto:[EMAIL PROTECTED] | ICQ UIN# 43320413 *****
Older PC & DOSnet forum http://www.egroups.com/group/survpc/
* I don't have a solution but I admire the problem.
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
