No issues here. We have upgraded everything across the board and turned on 4x4 on 10 enb's. We are seeing on average a 6 db increase in UE signal strength with the highest so far of 9 db. We had a customer installed last week in which the signal tested good from the front of the drive way but once it was installed we had a CINR0 of 0 and a CINR1 of -1. This was going to have to get uninstalled and one pissed off customer. We are shooting 3 miles through nothing but forest. When I say forest, I mean hundreds of pine trees between the UE and the tower. I decided to upgrade to the newest release and turned on 4x4. This same UE with an unusable signal now has a CINR0 of 10 and CINR1 of 10 with an RSRP of -106 and can pull 45 Mbps on a speedtest. Well done Telrad I must say!
On Sat, Jul 16, 2016 at 2:47 PM, Jeremy Austin <[email protected]> wrote: > > On Fri, Jul 15, 2016 at 5:38 PM, Matthew Carpenter < > [email protected]> wrote: > >> >> My issue last week, and hopefully this is fixed now, is after a eNB >> reboot the GPS will not init and therefore no S1. However rebooting the >> EPC will bring the GPS online and S1 up. I have done this about 6 times in >> the last week and it works everytime. >> > > That's very strange, Matt. > > No issues here so far with GPS init after upgrading to 6.6 — in fact, > upgrading fixed a similar issue on two ENBs that were having repeated GPS > comm loss on 6.5. > > Either way, something definitely changed with GPS code. > > > -- > Jeremy Austin > > (907) 895-2311 > (907) 803-5422 > [email protected] > > Heritage NetWorks > Whitestone Power & Communications > Vertical Broadband, LLC > > Schedule a meeting: http://doodle.com/jermudgeon > > _______________________________________________ > Telrad mailing list > [email protected] > http://lists.wispa.org/mailman/listinfo/telrad > > -- Sincerely, Justin Davis SkyWerx COO 970-731-9790
_______________________________________________ Telrad mailing list [email protected] http://lists.wispa.org/mailman/listinfo/telrad
