You have been collecting programs? I did not know there were any to collect. Do you have a list? I don't have much use for a .exe file but is your are source codes available that would be great.
On Thu, May 23, 2013 at 4:44 PM, EB4APL <[email protected]> wrote: > Hello, > > Since I bought my FE-5680A (10 MHz, 1 PPS variety), I have been collecting > control programs for it and keeping then in reserve. Now that I'm going to > box it with a distribution amp I tried some of them, first of all to adjust > the frequency against the GPS. I used Bob Campbel's VK4XV > "Fe5680Calibrator.exe" with good results. I have other programs which > interrogates the device and shows the hex dumps, but I would like to know > if there is a windows program that allows to send other that the offset > related commands to the device and get the responses not in hex but > translated to plain language. In fact I don't know if there are > housekeeping commands for reading thinks like the lock status or the lamp > voltage like the analog outputs of the FRS-C and others. > > Thanks in advance, > Ignacio EB4APL > ______________________________**_________________ > time-nuts mailing list -- [email protected] > To unsubscribe, go to https://www.febo.com/cgi-bin/** > mailman/listinfo/time-nuts<https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts> > and follow the instructions there. > -- Chris Albertson Redondo Beach, California _______________________________________________ time-nuts mailing list -- [email protected] To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts and follow the instructions there.
