On 02/09/08 11:22, Klaus Schmidinger wrote:
> On 02/08/08 17:58, Klaus Schmidinger wrote:
>> On 02/08/08 17:40, Antti Hartikainen wrote:
>>> On Fri, Feb 08, 2008 at 04:12:04PM +0100, Klaus Schmidinger wrote:
>>>>>> On 17/10/2007, *Arthur Konovalov* <[EMAIL PROTECTED] <mailto:[EMAIL 
>>>>>> PROTECTED]>> 
>>>>>> wrote:
>>>>>>     Hi all!
>>>>>>     Our local cable operator transmit on same frequency FTA and scrambled
>>>>>>     channels.
>>>>>>     During recording on FTA channel it is not possible to switch to any
>>>>>>     scrambled channel on the same frequency.
>>>>>>     "Channel not available!" message received.
>>>>>>     At the same time, when recording scrambled channel, switching to FTA 
>>>>>> or
>>>>>>     to other scrambled works.
>>>>>>     This behavior introduced with vdr-1.5.x versions (at least since 
>>>>>> 1.5.2,
>>>>>>     if I remember correctly).
>>>>>>     vdr-1.4.7 performs fine in same situation.
>>>> - start VDR with only a single FF card with one CAM
>>> What about with budget card? With budget cards it happened for me.
>> I don't have a budget card with CAM in my system.
> For further testing I have now modified my cDevice::GetDevice(const cChannel 
> *Channel, int Priority, bool LiveView)
> function so that it never returns the primary device. So VDR always runs in
> Transfer-Mode, and both the encrypted and the FTA channel will have to
> be fetched from my second FF card with CAM (which would then act like
> a budget card).
> Even in this constellation everything worked as expected, and I was able
> to record the encrypted channel and switch live between the FTA and the
> encrypted channel.

I just read your original posting again, and there you described the problem
the other way round. So I also tested recording the FTA channel and then 
to the encrypted channel, but this also works fine here.

So I'm afraid I don't know what's causing this for you.


vdr mailing list

Reply via email to