the first spacing is right out of dale clemens book good luck dan ----- Original Message ----- From: "Desert Eagle" <[EMAIL PROTECTED]> To: <[EMAIL PROTECTED]> Sent: Wednesday, December 25, 2002 7:32 PM Subject: Re: [VFB] 8' rod guild placement ???
> Thanks Dan and everyone, I will compare it with what John sends, (unless it > matches) and do the tests. This should prove to be interesting, he dropped > off the rod a while ago and it has been repaired at least twice, the tip > section is "Spliced" so it may take some doing, ( both cosmetic and > functionally) to make it cast properly. Seams folks think I can fix > anything... > Jimi > > > 4,8,14,21,29,37,45 1/2,54,65 or put the top guide 4 1/2 inches from the > tip, the stripping guide 28 to 34 inches from the butt, space out the rest > in a eye pleasing pattern the do a stress test. Flip the rod over with a > line from the butt to the tip and bend the rod using the line adjust the > guides when the line touches the blank. Dan > ----- Original Message ----- > From: "Desert Eagle" <[EMAIL PROTECTED]> > To: <[EMAIL PROTECTED]> > Sent: Wednesday, December 25, 2002 4:53 PM > Subject: [VFB] 8' rod guild placement ??? > > > > Dose anyone have the placement measurements for an 8' fiberglass fly rod ? > A > > friend of mine has one that all the guilds are gone off of it and he wants > > me to try to "Fix" it. More than likely I will have to remove the epoxy > > finish off of it as well, any tips ? And, before anyone asks, this rod was > > "re-built" ounce before so I have no idea which guild marks are the > correct > > ones, whoever did it before just "Stuck" them on and believe me, they were > > "Way" off of what it should have been. > > > > Thanks, > > Jimi > > > > > > > >
