The throttle cable is a good idea, I would not have thought soldering would hold long term. Is this plumbing solder you used? What did you do about the original Kadron fuel "T"? How did you mount it and keep it out of the way? Scott 73 Thing
--- Patrick Caswell <[EMAIL PROTECTED]> wrote: > Scott, > I had the same problem with full throttle. I used > washers to fix that as for > a throttle cable I bought a heavy duty cable from > Aircooled.net and after I > hooked it all up I cut it and soldered the end of > the cable. > The part # is FSC0004. > I think they are $16.00 > I will never replace another cable. > I have Taylor 409 spark plug wires and I wire tied > then in pairs. Routed > them over the linkage and attached them to the fan > shroud in the stock outer > most location. > > Patrick Caswell > 1964 Deluxe Beetle > > > > > -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf > Of Scott Sportsman > Sent: Sunday, May 11, 2008 8:23 PM > To: Air-Cooled Volkswagen Discussion List > Subject: Re: [vintagvw] Kadrons and Lowbugget.com > linkage help > > Thanks Patrick! I messed with it and I think I > figured > out the basics of it. I do have an issue getting it > to > full throttle because that golden bar that attaches > to > the fan housing gets in the way just a little bit. I > think a well placed washer or two will fix that. > I do need to figure out a place to mount the fuel > line > "T". It was mounted on the original linkage, I don't > know what I am supposed to do with it now. And, I > need > to run my spark plug wires a different route as they > rub on the linkage when it moves. One last thing...I > need a shorter throttle cable now. What do you use? > > > > > --- Patrick Caswell <[EMAIL PROTECTED]> wrote: > > > Scott, > > I have the same linkage but I do not have a > picture. > > I will try to take > > some. Is there anything special you are looking > for? > > > > Patrick Caswell > > 1964 Deluxe Beetle > > > > > > > > > > -----Original Message----- > > From: [EMAIL PROTECTED] > > [mailto:[EMAIL PROTECTED] On Behalf > > Of Scott Sportsman > > Sent: Sunday, May 11, 2008 12:27 PM > > To: [EMAIL PROTECTED]; [EMAIL PROTECTED] > > Subject: [vintagvw] Kadrons and Lowbugget.com > > linkage help > > > > I just purchased the lowbugget.com (I believe > these > > are very similar to Scat)upgraded linkage for my > > worn > > out kadron linkage. Anyone have any pictures of > your > > setup? > > Thanks, > > Scott > > 73 Thing > > > > _______________________________________________ > > vintagvw site list > > [email protected] > > http://lists.sjsu.edu/mailman/listinfo/vintagvw > > > > No virus found in this incoming message. > > Checked by AVG. > > Version: 7.5.524 / Virus Database: 269.23.15/1426 > - > > Release Date: 5/10/2008 > > 11:12 AM > > > > No virus found in this outgoing message. > > Checked by AVG. > > Version: 7.5.524 / Virus Database: 269.23.15/1426 > - > > Release Date: 5/10/2008 > > 11:12 AM > > > > > > _______________________________________________ > > vintagvw site list > > [email protected] > > http://lists.sjsu.edu/mailman/listinfo/vintagvw > > > > _______________________________________________ > vintagvw site list > [email protected] > http://lists.sjsu.edu/mailman/listinfo/vintagvw > > No virus found in this incoming message. > Checked by AVG. > Version: 7.5.524 / Virus Database: 269.23.15/1426 - > Release Date: 5/10/2008 > 11:12 AM > > No virus found in this outgoing message. > Checked by AVG. > Version: 7.5.524 / Virus Database: 269.23.15/1426 - > Release Date: 5/10/2008 > 11:12 AM > > > > _______________________________________________ > vintagvw site list > [email protected] > http://lists.sjsu.edu/mailman/listinfo/vintagvw > _______________________________________________ vintagvw site list [email protected] http://lists.sjsu.edu/mailman/listinfo/vintagvw
