Dave, What I did was soldered the cable before I cut it.

Patrick


---- "Dave C. Bolen" <[EMAIL PROTECTED]> wrote: 
> Scott,
> 
> What I have used is brass rod that fits over the cable end and then 
> soldered it.
> 
> The brass rod is available at Lowe's and Hobby lobby as well i think.
> 
> It makes a really nice finish to the cable and helps keep the solder where 
> it is supposed to go.
> 
> Use a cutoff wheel of some sort(dremel or larger) to cut the cable...this 
> will keep it from trying to unravel as you cut it.
> 
> Cheers, dave
> 
> -- 
> -------------------------------------------------------------------
> Enough sunlight reaches the Earth *every* hour to meet the world's
> energy demand for an entire year.....so, what do we do with it?
> 
> 
> On Mon, 12 May 2008, Scott Sportsman wrote:
> 
> > The throttle cable is a good idea, I would not have
> > thought soldering would hold long term. Is this
> > plumbing solder you used?
> > What did you do about the original Kadron fuel "T"?
> > How did you mount it and keep it out of the way?
> > Scott
> > 73 Thing
> >
> >
> > --- Patrick Caswell <[EMAIL PROTECTED]> wrote:
> >
> >> Scott,
> >> I had the same problem with full throttle. I used
> >> washers to fix that as for
> >> a throttle cable I bought a heavy duty cable from
> >> Aircooled.net and after I
> >> hooked it all up I cut it and soldered the end of
> >> the cable.
> >> The part # is FSC0004.
> >> I think they are $16.00
> >> I will never replace another cable.
> >> I have Taylor 409 spark plug wires and I wire tied
> >> then in pairs. Routed
> >> them over the linkage and attached them to the fan
> >> shroud in the stock outer
> >> most location.
> >>
> >> Patrick Caswell
> >> 1964 Deluxe Beetle
> >>
> >>
> >>
> >>
> >> -----Original Message-----
> >> From: [EMAIL PROTECTED]
> >> [mailto:[EMAIL PROTECTED] On Behalf
> >> Of Scott Sportsman
> >> Sent: Sunday, May 11, 2008 8:23 PM
> >> To: Air-Cooled Volkswagen Discussion List
> >> Subject: Re: [vintagvw] Kadrons and Lowbugget.com
> >> linkage help
> >>
> >> Thanks Patrick! I messed with it and I think I
> >> figured
> >> out the basics of it. I do have an issue getting it
> >> to
> >> full throttle because that golden bar that attaches
> >> to
> >> the fan housing gets in the way just a little bit. I
> >> think a well placed washer or two will fix that.
> >> I do need to figure out a place to mount the fuel
> >> line
> >> "T". It was mounted on the original linkage, I don't
> >> know what I am supposed to do with it now. And, I
> >> need
> >> to run my spark plug wires a different route as they
> >> rub on the linkage when it moves. One last thing...I
> >> need a shorter throttle cable now. What do you use?
> >>
> >>
> >>
> >>
> >> --- Patrick Caswell <[EMAIL PROTECTED]> wrote:
> >>
> >>> Scott,
> >>> I have the same linkage but I do not have a
> >> picture.
> >>> I will try to take
> >>> some. Is there anything special you are looking
> >> for?
> >>>
> >>> Patrick Caswell
> >>> 1964 Deluxe Beetle
> >>>
> >>>
> >>>
> >>>
> >>> -----Original Message-----
> >>> From: [EMAIL PROTECTED]
> >>> [mailto:[EMAIL PROTECTED] On Behalf
> >>> Of Scott Sportsman
> >>> Sent: Sunday, May 11, 2008 12:27 PM
> >>> To: [EMAIL PROTECTED]; [EMAIL PROTECTED]
> >>> Subject: [vintagvw] Kadrons and Lowbugget.com
> >>> linkage help
> >>>
> >>> I just purchased the lowbugget.com (I believe
> >> these
> >>> are very similar to Scat)upgraded linkage for my
> >>> worn
> >>> out kadron linkage. Anyone have any pictures of
> >> your
> >>> setup?
> >>> Thanks,
> >>> Scott
> >>> 73 Thing
> >>>
> >>> _______________________________________________
> >>> vintagvw site list
> >>> [email protected]
> >>> http://lists.sjsu.edu/mailman/listinfo/vintagvw
> >>>
> >>> No virus found in this incoming message.
> >>> Checked by AVG.
> >>> Version: 7.5.524 / Virus Database: 269.23.15/1426
> >> -
> >>> Release Date: 5/10/2008
> >>> 11:12 AM
> >>>
> >>> No virus found in this outgoing message.
> >>> Checked by AVG.
> >>> Version: 7.5.524 / Virus Database: 269.23.15/1426
> >> -
> >>> Release Date: 5/10/2008
> >>> 11:12 AM
> >>>
> >>>
> >>> _______________________________________________
> >>> vintagvw site list
> >>> [email protected]
> >>> http://lists.sjsu.edu/mailman/listinfo/vintagvw
> >>>
> >>
> >> _______________________________________________
> >> vintagvw site list
> >> [email protected]
> >> http://lists.sjsu.edu/mailman/listinfo/vintagvw
> >>
> >> No virus found in this incoming message.
> >> Checked by AVG.
> >> Version: 7.5.524 / Virus Database: 269.23.15/1426 -
> >> Release Date: 5/10/2008
> >> 11:12 AM
> >>
> >> No virus found in this outgoing message.
> >> Checked by AVG.
> >> Version: 7.5.524 / Virus Database: 269.23.15/1426 -
> >> Release Date: 5/10/2008
> >> 11:12 AM
> >>
> >>
> >>
> >> _______________________________________________
> >> vintagvw site list
> >> [email protected]
> >> http://lists.sjsu.edu/mailman/listinfo/vintagvw
> >>
> >
> > _______________________________________________
> > vintagvw site list
> > [email protected]
> > http://lists.sjsu.edu/mailman/listinfo/vintagvw
> >
> >
> 
> _______________________________________________
> vintagvw site list
> [email protected]
> http://lists.sjsu.edu/mailman/listinfo/vintagvw

_______________________________________________
vintagvw site list
[email protected]
http://lists.sjsu.edu/mailman/listinfo/vintagvw

Reply via email to