Yes, ethernet is shielded. The good stuff. It's like almost 1/2 inch cat5.
The tower has pagers, lots of trango, few backhauls, canopy 900, and
some more I believe. The only thing up with me is some trango, and they
have no problem. I am pointing at a bad cable.
Brian
Harold Bledsoe wrote:
The 800 to 1300mA consumption is at 3.3V. The 700mA from the PS is at
48V so there is probably plenty of power going to it.
Is the CAT5 shielded? What else is on the tower?
-Hal
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Mark McElvy
Sent: Wednesday, September 13, 2006 8:20 AM
To: WISPA General List
Subject: RE: [WISPA] MT power supplies
I am surprised no one has mentioned this. I looked up power consumption
on the SR5 and it shows 800 to 1300 mA each. You state your power supply
is 700mA. I did not look up power consumption for the RB532 but I would
think you would need at least a 3A supply.
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Brian Rohrbacher
Sent: Tuesday, September 12, 2006 11:51 AM
To: WISPA General List
Subject: Re: [WISPA] MT power supplies
So, does anyone know if it looks like I would be fine on the power side
of things?
I have tweaked the ethernet port settings for no gain.
Next step is to get climbing 280ft to replace board, but I'd like to
confirm power first.
Brian
Brian Rohrbacher wrote:
I have a RB 532 on 300 foot of cat 5 with 2 sr5.
I'm using poe 48v .700a power supply.
I'm seeing weirdness.
Do I have enough "juice"
Brian
--
WISPA Wireless List: [email protected]
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
