I have a NS5M (back haul) which is passing through power and data to a BulletM2 as AP and I recently had some strangeness - I changed settings in the NS5M and power to the BulletM2 would start cycling. The BulletM2 is my access to the NS5M so I couldn't get in that way. I also couldn't browse in via ethernet. This happened more than once. One time I think cycling the power fixed it. The last time it happened I couldn't browse into the NS5M so I had to do a hard reset and reprogram it.
Greg On Sep 24, 2010, at 8:20 PM, Robert West wrote: > Today I finally figured out an Issue I’ve been having with a NanoStation5M. > I have a customer who wanted service, was in trees but had a hot signal out > at the road. Dug a 4 foot hole, put in 2 10 foot sections of rigid conduit > and 5 bags of concrete. Ran an underground line of Cat5e, double shielded > and flooded cable with ground wire to his house. That was 5 months or so > ago. At the beginning of August, he called me and said his neighbor wanted > service. Same trees so I took the AirGrid down, put up a Nano5M and plugged > a Nano loco2 into the secondary port and shot it at a second Nano Loco2 at > his place. Replaced my weird Airgrid > > Worked perfectly, everyone happy. 2 weeks ago I get a call, neighbor not > working. I go out, no power light on the Nano at the pole. I figure, bad > crimp……. Take it down, make up a new wire to connect the two, fires up. All > good. 2 days later, same issue. I reset it all to defaults, reconfigure, > all okay. 2 days later, same thing. I downgrade firmware to 5.2. Couple of > days later, no signal again. I’ll also add I was getting some “weird” lag > at the AP that this setup was feeding off of. So I was fighting two battles. > Then today, I find that the PoE Pass Through check box is empty. DUH! I > check it, apply, comes back empty. I do it again, same issue. I go out and > I can connect my laptop through the secondary port but it will not give any > voltage. > > I checked my lag time issue at the AP. GONE! > > I then checked in the UBNT forums…………. It’s an issue. After 20 days PoE on > the secondary Nano port starts to die. Replaced it with another Nano5M, > working fine but looks like I’ll be coming up with another MacGyver solution > to service this dude………. > > Just so ya knows. > > Bob- > > > > > > > -------------------------------------------------------------------------------- > WISPA Wants You! Join today! > http://signup.wispa.org/ > -------------------------------------------------------------------------------- > > WISPA Wireless List: [email protected] > > Subscribe/Unsubscribe: > http://lists.wispa.org/mailman/listinfo/wireless > > Archives: http://lists.wispa.org/pipermail/wireless/
-------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: [email protected] Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/
