Thanks - shall persist Cheers Ken VK4GC
On Tue, 27 Nov 2018 at 09:42, Bill Somerville <g4...@classdesign.com> wrote: > Hi Ken, > > comments in line below. > > On 26/11/2018 23:15, Ken Myers wrote: > > 2 installations - > > 1 MSSurface Win10 up to date, 2 radios (FT991a & FTdx3000 both USB) - > > non decode, > > 2 HP Allinone with FT897/Singnalink. - non decode, > > (both setups using HRD (up to date) for CAT control) > This combination of rig and interface requires a specific setup. The > FT-817/857/897(D) series of rigs do not accept CAT commands while > transmitting. You must *not* check the settings option > "Settings->General->Allow Tx frequency changes while transmitting" and > you must set the SignaLink delay knob to minimum. You should set the > WSJT-X PTT configuration "Settings->Radio->PTT Method" to "VOX" although > some have found it necessary to use the CAT PTT Method to avoid any CAT > commands while the rig is in Tx mode. > > > > For all: > > 1.9.1 works great > > 2.0 RC3 works great > > 2.0 RC4 good waterfall (therefore good audio present) - NO decode. > > > > uninstalling/reinstalling forward and back through versions gives the > > same result. > > > > i have concluded: > > 1 I must be holding my mouth wrong - OR > > 2 I have missed a new setting. > > 3 When I have been looking/testing RC4, no RC4 (77 bit) > > transmissions. Not sure here as I have been especially been looking > > top band. > > > > 2 probably!! > > > Almost certainly 3, there has been a relatively low usage to 77-bit FT8 > on the normal HF FT8 sub-bands. It seems that most users of RC4 have > reverted to v1.9.1 so the volume of 77-bit traffic is low except for a > couple of days after a beta release. It would be good if users of RC5 > could stick with it and try to drive up the level of activity so that > issues can be discovered before the final GA release. > > 73 > Bill > G4WJS. > > > > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel > -- Cheers Ken Myers Sunnybank Hills QLD AUS M +61 414 487 004
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
