Ken,
did you read the Quick Start guide. Release Candidates 4 & 5 (released
today) are only 77bit, they will NOT decode 75 bit FT8, which is
probably why you're not seeing decodes on a normal FT8 frequency. The
Quick Start advises that you use the standard FT8 frequency, but use the
audio range above 2000 for 77 bit work until the General Release in
December.
Neil, KN3ILZ
On 11/26/2018 6:15 PM, Ken Myers wrote:
Hi
I have been successfully been using RSC3 then changing to RSC4 there
was no decode of waterfall content. FT8 mode.
2 installations -
1 MSSurface Win10 up to date, 2 radios (FT991a & FTdx3000 both USB) -
non decode,
2 HP Allinone with FT897/Singnalink. - non decode,
(both setups using HRD (up to date) for CAT control)
For all:
1.9.1 works great
2.0 RC3 works great
2.0 RC4 good waterfall (therefore good audio present) - NO decode.
uninstalling/reinstalling forward and back through versions gives the
same result.
i have concluded:
1 I must be holding my mouth wrong - OR
2 I have missed a new setting.
3 When I have been looking/testing RC4, no RC4 (77 bit)
transmissions. Not sure here as I have been especially been looking
top band.
2 probably!!
In the words of the rich young ruler to Jesus - "What must I do to be
saved?"
The other problem is occasionally the FT897 does not let go of
transmit after sending.
Solved by closing WSJTX. Have tried 2 soundcards, Signalink and
Rigblaster P&P, - persistent intermittent. MIGHT be my aging FT897 -
haven't ruled that out.
Great Program Great work.
Thanks
--
Cheers
Ken Myers
VK4GC
Sunnybank Hills QLD AUS
M +61 414 487 004
---
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
