1 decode on 20m - frq 383 ?? seems to work. Like fishing - have to wait quietly or NOISILY sent out string of CQ - no fish. Checking 6m
THanks On Tue, 27 Nov 2018 at 09:53, Ken Myers <kenmyersglo...@gmail.com> wrote: > Thanks - shall persist > > Cheers Ken > VK4GC > > On Tue, 27 Nov 2018 at 09:42, Bill Somerville <g4...@classdesign.com> > wrote: > >> Hi Ken, >> >> comments in line below. >> >> On 26/11/2018 23:15, Ken Myers wrote: >> > 2 installations - >> > 1 MSSurface Win10 up to date, 2 radios (FT991a & FTdx3000 both USB) - >> > non decode, >> > 2 HP Allinone with FT897/Singnalink. - non decode, >> > (both setups using HRD (up to date) for CAT control) >> This combination of rig and interface requires a specific setup. The >> FT-817/857/897(D) series of rigs do not accept CAT commands while >> transmitting. You must *not* check the settings option >> "Settings->General->Allow Tx frequency changes while transmitting" and >> you must set the SignaLink delay knob to minimum. You should set the >> WSJT-X PTT configuration "Settings->Radio->PTT Method" to "VOX" although >> some have found it necessary to use the CAT PTT Method to avoid any CAT >> commands while the rig is in Tx mode. >> > >> > For all: >> > 1.9.1 works great >> > 2.0 RC3 works great >> > 2.0 RC4 good waterfall (therefore good audio present) - NO decode. >> > >> > uninstalling/reinstalling forward and back through versions gives the >> > same result. >> > >> > i have concluded: >> > 1 I must be holding my mouth wrong - OR >> > 2 I have missed a new setting. >> > 3 When I have been looking/testing RC4, no RC4 (77 bit) >> > transmissions. Not sure here as I have been especially been looking >> > top band. >> > >> > 2 probably!! >> > >> Almost certainly 3, there has been a relatively low usage to 77-bit FT8 >> on the normal HF FT8 sub-bands. It seems that most users of RC4 have >> reverted to v1.9.1 so the volume of 77-bit traffic is low except for a >> couple of days after a beta release. It would be good if users of RC5 >> could stick with it and try to drive up the level of activity so that >> issues can be discovered before the final GA release. >> >> 73 >> Bill >> G4WJS. >> >> >> >> _______________________________________________ >> wsjt-devel mailing list >> wsjt-devel@lists.sourceforge.net >> https://lists.sourceforge.net/lists/listinfo/wsjt-devel >> > > > -- > Cheers > > Ken Myers > > Sunnybank Hills QLD AUS > M +61 414 487 004 > > -- Cheers Ken Myers Sunnybank Hills QLD AUS M +61 414 487 004
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
