On 16/01/2019 11:41, jeff millar wrote:
There was a station operating on a reported frequency of 68 Hz. It
showed up on the waterfall at that location. I have my Rx passband
set to cover those low frequencies.
The green frequency marker was placed on 200 Hz. When I tried to
shift-click to his frequency, the Tx would only go as low as 200 Hz.
How did that operator set the Tx frequency to 68 Hz?
We worked, no problem. But the display doesn't match the operation.
Any recommendations for this situation?
jeff, wa1hco
Hi Jeff,
I will assume you are asking about FT8 operation on HF. It is possible
that your QSO partner has his VFO dial frequency lower than yours.
73
Bill
G4WJS.
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel
