As a matter of interest, Bill, why has the software been written not to
allow TX below 200 Hz?  I've always wondered.
73
Chris
G4IFX

On Wed, 16 Jan 2019, 11:49 Bill Somerville <g4...@classdesign.com wrote:

> On 16/01/2019 11:41, jeff millar wrote:
> > There was a station operating on a reported frequency of 68 Hz.  It
> > showed up on the waterfall at that location.  I have my Rx passband
> > set to cover those low frequencies.
> >
> > The green frequency marker was placed on 200 Hz.  When I tried to
> > shift-click to his frequency, the Tx would only go as low as 200 Hz.
> >
> > How did that operator set the Tx frequency to 68 Hz?
> >
> > We worked, no problem.  But the display doesn't match the operation.
> >
> > Any recommendations for this situation?
> >
> > jeff, wa1hco
>
> Hi Jeff,
>
> I will assume you are asking about FT8 operation on HF. It is possible
> that your QSO partner has his VFO dial frequency lower than yours.
>
> 73
> Bill
> G4WJS.
>
>
>
> _______________________________________________
> wsjt-devel mailing list
> wsjt-devel@lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/wsjt-devel
>
_______________________________________________
wsjt-devel mailing list
wsjt-devel@lists.sourceforge.net
https://lists.sourceforge.net/lists/listinfo/wsjt-devel

Reply via email to