Bill, My mistake. You are absolutely right. I have changed "Settings->Radio-Mode" to "None" and forgot about it.
This was done because selecting "IC-7300-DATA" as Omni-Rig's "Rig type" and selecting "Data/Pkt" as WSJT-X's "Radio-Mode" forced the transceiver to use the 1.2Khz "FIL2" IF filter rather than the 3.0KHz "FIL1" IF filter. Split mode was working, but the reception bandwidth was horrible. I have send an improved IC-7300 rig definition file for consideration by the Omni-Rig author. 73, Zeev 4X5ZS On Wed, Dec 18, 2019 at 12:24 PM Bill Somerville <g4...@classdesign.com> wrote: > Zeev, > > that's not correct. WSJT-X will control the mode of your rig if you wish > it to. The options available in the "Settings->Radio-Mode" group > determine the mode used on your rig: > > "None" - WSJT-X does not attempt to control the rig's mode, > "USB" - WSJT-X sets the rig mode to USB, > "Data/Pkt" - WSJT-X sets the appropriate USB data mode on the rig. > > Note that the "Data/Pkt" option only works if your rig has a suitable > AFSK data mode. Note also that Omni-Rig is quite limited in the rig > modes that it supports and the Omni-Rig .ini file for your rig may > require modifications to support a suitable USB data mode, this is > particularly so with rigs that have both AFSK and FSK data modes available. > > 73 > Bill > G4WJS. > > On 18/12/2019 06:57, Zeev Stadler wrote: > > When using Omni-Rig, I believe WSJT-X Does not control the operation > > mode of the IC-7300 regardless of the "Split Operation" selection. > > As far as I can tell, WSJT-X assumes the user is responsible for > > selecting "USB-D" for both VFO-A and VFO-B. > > > > Here is a scenario that demonstrated this: > > > > - Change the operation mode to "LSB" using the touch screen > > - Change the frequency a bit using the VFO knob > > - Start WSJT-X > > - Set "Split Operation" to "None" using File -> Settings... -> Radio > > - Select the current band in WSJT-X > > - Verify that the proper frequency is set > > - Notice that the mode remains "LSB" > > - Select the "CQ" Command > > - Click the "Enable Tx" > > - Notice that the mode remains "LSB" during the transmission > > - Click "Halt Tx" > > - Notice that the mode remains "LSB" after the transmission > > > > An Omni-Rig log file, created when Omni-Rig was working exclusively > > with WSJT-X, is available at > > https://gist.github.com/zstadler/960943fb17f2b9f74085819da79329ef > > > > 73, > > Zeev > > 4X5ZS > > > > > _______________________________________________ > wsjt-devel mailing list > wsjt-devel@lists.sourceforge.net > https://lists.sourceforge.net/lists/listinfo/wsjt-devel >
_______________________________________________ wsjt-devel mailing list wsjt-devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/wsjt-devel
