Oh yea, and not saying they are, but if the clips tieing the ground are metallic they act like a choke.
It does look nice though and that is a nice mount. On May 12, 2015 8:33 PM, wrote: > Technically you shouldn't bend a radius greater than six inches, turn more > than a 90 degree angle, or place ground within six inches of any conductor > that is not a ground. > On May 12, 2015 7:03 PM, "Tyler Treat" <[email protected]> > wrote: > >> Sharp. Nice and clean. Love it. >> >> Not that I’d ever question your work, but Is it considered copacetic to >> coil the ground like that? >> >> >> >> *From:* Af [mailto:[email protected]] *On Behalf Of *Jaime Solorza >> *Sent:* Tuesday, May 12, 2015 10:01 PM >> *To:* Animal Farm >> *Subject:* [AFMUG] Stand off mount on uneven surface >> >> >> >> Bolt in anchors 5 inch...a 3/4 nut flush to face on each of 4 bolts. >> Install mount. Then washer , pressure washer and nut. Levels on mount. >> Then adjust back nut until mount is level. Luckily didn't need too much to >> get..tighten up and complete installation. 6 more to go. >> Jaime Solorza >> >
