well I am low man on totem pole here. They did challenge a tower height my math told me needed to be 35 ft tall. Once we erected it, I climbed and took picture of distance water tank no longer obstructed by warehouses in the near field, they listen more to me...I told them to trust the math.
Jaime Solorza Wireless Systems Architect 915-861-1390 On Wed, May 13, 2015 at 7:46 AM, Lewis Bergman <[email protected]> wrote: > No matter if they really are, the client is always right. > On May 13, 2015 7:52 AM, "Jaime Solorza" <[email protected]> > wrote: > >> The steel ties have been an issue of contention. The SCADA supervisor >> for PSB requested they be mandatory and no dangling wires. I had ground >> wire separated on arm of mount and Brown Caldwell project mgr asked me to >> follow Heliax run. The ground is attached to air terminal and runs inside >> IMC through CBG rubber grommet as well as Heliax which has ground strap by >> antenna which is tied to air terminal. Grounding is to dedicated 10 ft >> rod. Inside building heliax connects to Polyphaser with ring terminal to >> isolated ground outside NEMA enclosure. Pigtail to MDS SD9 which has >> surge protection on data and power >> So far we haven't lost a radio to hits when sites have been hit. Replace >> fuse or arrester and back in business. No antenna or cables yet but rainy >> season is just starting. >> >> Jaime Solorza >> On May 13, 2015 12:36 AM, "Lewis Bergman" <[email protected]> >> wrote: >> >>> Oh yea, and not saying they are, but if the clips tieing the ground are >>> metallic they act like a choke. >>> >>> It does look nice though and that is a nice mount. >>> On May 12, 2015 8:33 PM, wrote: >>> >>>> Technically you shouldn't bend a radius greater than six inches, turn >>>> more than a 90 degree angle, or place ground within six inches of any >>>> conductor that is not a ground. >>>> On May 12, 2015 7:03 PM, "Tyler Treat" <[email protected]> >>>> wrote: >>>> >>>>> Sharp. Nice and clean. Love it. >>>>> >>>>> Not that I’d ever question your work, but Is it considered copacetic >>>>> to coil the ground like that? >>>>> >>>>> >>>>> >>>>> *From:* Af [mailto:[email protected]] *On Behalf Of *Jaime Solorza >>>>> *Sent:* Tuesday, May 12, 2015 10:01 PM >>>>> *To:* Animal Farm >>>>> *Subject:* [AFMUG] Stand off mount on uneven surface >>>>> >>>>> >>>>> >>>>> Bolt in anchors 5 inch...a 3/4 nut flush to face on each of 4 bolts. >>>>> Install mount. Then washer , pressure washer and nut. Levels on mount. >>>>> Then adjust back nut until mount is level. Luckily didn't need too much >>>>> to >>>>> get..tighten up and complete installation. 6 more to go. >>>>> Jaime Solorza >>>>> >>>>
