Yes they are snug to wall. The mount doesn't move at all. Prior to drilling after I mark hole position I use a chisel to clear area for drill bit to work better. Small indentation which keeps it from gliding. I will take a before and picture later today
Jaime Solorza On May 13, 2015 9:01 AM, "Bill Prince" <[email protected]> wrote: > I could be wrong, but I think you want the nut against the face of the > brick to be snugged up & not back off to achieve "level" on the mount. What > I would do is to snug up the nut on the face of the brick, & then add > washers to achieve level. > > If the nut on the face is not snugged, I think they might work loose? > > bp > <part15sbs{at}gmail{dot}com> > > On 5/12/2015 8:01 PM, Jaime Solorza wrote: > >> >> Bolt in anchors 5 inch...a 3/4 nut flush to face on each of 4 bolts. >> Install mount. Then washer , pressure washer and nut. Levels on mount. >> Then adjust back nut until mount is level. Luckily didn't need too much to >> get..tighten up and complete installation. 6 more to go. >> Jaime Solorza >> >> >
