Do you remember what ideal was supposed to be? Hopefully -64?
Josh Luthman Office: 937-552-2340 Direct: 937-552-2343 1100 Wayne St Suite 1337 Troy, OH 45373 On Mon, Oct 17, 2016 at 7:44 PM, Craig House <cr...@totalhighspeed.net> wrote: > The antennas were set to 23 DB antennas and I change them up after I took > this picture to 30 DBI dishes that I'm using. It did change the ideal > signal but it didn't change the actual signal > > Sent from my iPhone > > On Oct 17, 2016, at 18:41, Josh Luthman <j...@imaginenetworksllc.com> > wrote: > > Do you have your power/antennas set right? Between those two points and > the set power levels you're supposed to see -53... > > > Josh Luthman > Office: 937-552-2340 > Direct: 937-552-2343 > 1100 Wayne St > Suite 1337 > Troy, OH 45373 > > On Mon, Oct 17, 2016 at 7:37 PM, Craig House <cr...@totalhighspeed.net> > wrote: > >> It's always been pretty accurate in the past and I have a pretty >> wide-open view I'm 85 feet up on the water tower that sits on a mountaintop >> on one end and I'm 200 feet up on the building roof top on the other end. >> The odd part is that I am achieving that -65 signal on at least one of the >> chains. I have a feeling that it resting on the top of the tank is possibly >> causing some weird reflection >> >> Sent from my iPhone >> >> On Oct 17, 2016, at 18:34, Josh Luthman <j...@imaginenetworksllc.com> >> wrote: >> >> Doesn't include land cover I bet >> >> Josh Luthman >> Office: 937-552-2340 >> Direct: 937-552-2343 >> 1100 Wayne St >> Suite 1337 >> Troy, OH 45373 >> >> On Oct 17, 2016 7:25 PM, "Craig House" <cr...@totalhighspeed.net> wrote: >> >>> Wink planner shows that it supposed to be a -65 signal >>> >>> Sent from my iPhone >>> >>> On Oct 17, 2016, at 18:20, Josh Luthman <j...@imaginenetworksllc.com> >>> wrote: >>> >>> Plug into LinkPlanner >>> >>> Josh Luthman >>> Office: 937-552-2340 >>> Direct: 937-552-2343 >>> 1100 Wayne St >>> Suite 1337 >>> Troy, OH 45373 >>> >>> On Oct 17, 2016 7:11 PM, "Craig House" <cr...@totalhighspeed.net> wrote: >>> >>>> Very close to the top of the water tower on the remote end. It bottom >>>> of the dish is resting on hr tank because the mount wasn't stable enough >>>> with all the wind here today 45mph. I'll raise it up and brace the mount >>>> tomorrow and see what happens. >>>> >>>> Sent from my iPhone >>>> >>>> > On Oct 17, 2016, at 18:03, David Kunat <m...@davidkunat.com> wrote: >>>> > >>>> > There are only two polarities on th af-x series. >>>> > >>>> > The first two are the receive signals at the local device. >>>> > >>>> > The second two (Rem chain0 and Rem chain 1) are the remote device >>>> receive levels (at the far end of the link). >>>> > >>>> > Is there something in the way? Are you shooting close to the ground >>>> or close to tree tops on one end? >>>> > >>>> > >>>> > > On Oct 17, 2016, at 2:39 PM, Craig House <cr...@totalhighspeed.net> >>>> wrote: >>>> > > >>>> > > So when you have one chain that shows almost 20 dbi weaker than the >>>> other 3 how do you tell which end to troubleshoot? I have already tried to >>>> point both ends better but they are 22 miles apart by air. 45 minutes by >>>> drive and I dont want to just keep driving and climbing if someone can tell >>>> me which end has the problem. >>>> > > >>>> > > Craig >>>> > > <link.PNG> >>>> >>> >