I'll bet in that micro climate 18G wouldn't work any better at 7 miles than it would here. I can't get anything reliable over 4.5 miles here on 18G.
On Fri, Feb 23, 2018 at 2:29 PM Rory Conaway <[email protected]> wrote: > I would do all the shots less than 7 miles in 18GHz if you can’t get > 11GHz. > > > > Rory > > > > *From:* Af [mailto:[email protected]] *On Behalf Of *Carl Peterson > *Sent:* Friday, February 23, 2018 12:39 PM > *To:* [email protected] > > > *Subject:* Re: [AFMUG] Question for the collective... > > > > For the shorter(4-5 mile) links you could do something like the Siklu > EX2500 with 2' antennas and a hot fall over (This is a licensed feature but > its cheap) They also have an antenna with integrated 5GHz so if you were > doing the backup in 5GHz you could do it all on one antenna. The backup > radio plugs into the Siklu and it does the fall over for you so you don't > need to do that in routing etc. > > > > On Fri, Feb 23, 2018 at 2:05 PM, Mathew Howard <[email protected]> > wrote: > > Yeah, if the actual requirements are a full duplex 1 gig link, then it's > going to be expensive. It sounds like this is all going to be sharing the > existing 1 gig fiber that they already have, so I suspect that it probably > doesn't really need to be a full gig everywhere... if that's the case, then > it can be done a lot cheaper, and with a lot less spectrum. An 11ghz radio > on a single 80mhz channel can do over 600Mbps, and can be had relatively > cheap. > > The cheapest way to get something that's close enough to a gig that won't > matter to most people would be using B11's, but that's not full duplex, and > it would burn up a LOT of spectrum... actually, I'm not sure if it would > even be possible to run 4 B11 links that close to the same direction, even > if the entire band is completely clear... > > > > On Fri, Feb 23, 2018 at 12:04 PM, Faisal Imtiaz <[email protected]> > wrote: > > so.. here is how things will break down for you .... > > > > to do 1G duplex links, you have a few choices.. > > 60ghz or 80ghz (very short links) > > or you do 24ghz (short to medium, depending on rain fade) > > 11ghz or 6ghz.. you need to have freq available, and will > be looking at roughly $15k / link > > ( the pricing on 1G links in the range of > $12k to $15k may change in depending on pricing announcement by > Bridgewave's new radios). > > > > Now if the requirements were say sub 1G (500meg to 800meg) then you have > a few more options > > which can be in the range of $3k to $7k per link > > > > Bigger challenge will be finding enough licensed spectrum to do what is > needed. > > > > Best of luck. > > > > Regards. > > > > Faisal Imtiaz > Snappy Internet & Telecom > http://www.snappytelecom.net > > Tel: 305 663 5518 x 232 <(305)%20663-5518> > > Help-desk: (305)663-5518 <(305)%20663-5518> Option 2 or Email: > [email protected] > > > ------------------------------ > > *From: *"Jaime Solorza" <[email protected]> > *To: *"Animal Farm" <[email protected]> > *Sent: *Friday, February 23, 2018 12:49:31 PM > *Subject: *Re: [AFMUG] Question for the collective... > > Not familiar with this product....will download specs > > Jaime Solorza > > > > On Feb 23, 2018 9:56 AM, "Dave" <[email protected]> wrote: > > Bang it out with PTP820C ring > Most of the switching is now for doing such a thing is built right into > the ODU if you go all outdoor. > They do make a split unit or an all indoor unit as well. > > > On 02/23/2018 10:30 AM, Jaime Solorza wrote: > > That is what I was thinking...4 P2P links and tie them in at office...I > wonder if you could colocate 4 11GHz links successfully? > > Jaime Solorza > > > > On Feb 23, 2018 9:07 AM, "Lewis Bergman" <[email protected]> wrote: > > If budget isn't a problem, I would put up P2P to every location in a ring > topology. A little routing or switch magic (your preference) and you have a > redundant setup. > > > > On Fri, Feb 23, 2018 at 10:03 AM Jeremy <[email protected]> wrote: > > I would assume that you can add a fourth location... > > > > On Fri, Feb 23, 2018 at 9:00 AM, Jeremy <[email protected]> wrote: > > CL has an option called Fiber Plus that will give them a gig at three > locations. ISPs are not eligible, as it no longer allows resale. If they > can get that deal, it would be your best bet. They tie everything together > on a VLAN. > > On Fri, Feb 23, 2018 at 8:33 AM, Jaime Solorza <[email protected]> > wrote: > > Going to have a meeting with company that has a 1GBps feed to office from > CenturyLink. They have four remote locations (4.1, 4.4, 6.2 and 9.1 miles > ) from office. All are west and with a 60 degree span if I was using a > sectored antenna. On email, they indicated they want licensed links and > want to deliver 1GBps to each location. Not sure if they are adding more > CenturyLink feeds to provide 1Gig to each site. I wonder what you guys > would recommend? I know it's a energy company and Pecan farm outfit in > eastern NM. Let's say they have good budget , dazzle me with your > suggestions? > > Jaime Solorza > > > > -- > [image: image001.jpg] > > > > > > > > > > <https://maps.google.com/?q=401+E+Pratt+St,+Ste+2553%0D+Baltimore,+MD+21202%0D+(410&entry=gmail&source=g> > > <https://maps.google.com/?q=401+E+Pratt+St,+Ste+2553%0D+Baltimore,+MD+21202%0D+(410&entry=gmail&source=g> > > -- > > Carl Peterson > > *PORT NETWORKS* > > 401 E Pratt St, Ste 2553 > <https://maps.google.com/?q=401+E+Pratt+St,+Ste+2553%0D+Baltimore,+MD+21202%0D+(410&entry=gmail&source=g> > > Baltimore, MD 21202 > <https://maps.google.com/?q=401+E+Pratt+St,+Ste+2553%0D+Baltimore,+MD+21202%0D+(410&entry=gmail&source=g> > > (410) 637-3707 >
