I got the WLL kit and the directions were very thorough. The thermocouple can be a problem, but no worse than any other threaded fitting on the machine. You could always try removing it before ordering the PID to be sure you can. b
Sent from my iPhone > On May 12, 2016, at 16:49, BklynJim <[email protected]> wrote: > > Thanks Herman. I am leaning toward the PID but I'm also a bit worried about > running into problems with the project. I read your post about putting in > the PID and it seemed straight forward, but on a few of the other posts I > found, it seems people had trouble removing the thermocouple or with the > wiring. Did you get your conversion kit from WLL? Any pointers? > > -- > You received this message because you are subscribed to the Google Groups > "Brewtus" group. > To unsubscribe from this group and stop receiving emails from it, send an > email to [email protected]. > To post to this group, send email to [email protected]. > Visit this group at https://groups.google.com/group/brewtus. > For more options, visit https://groups.google.com/d/optout. -- You received this message because you are subscribed to the Google Groups "Brewtus" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To post to this group, send email to [email protected]. Visit this group at https://groups.google.com/group/brewtus. For more options, visit https://groups.google.com/d/optout.
