Replies to this message are sent to The Chevelle Mailing List
------------------------------------------------------------
Denny
I drilled may 3/8 inch holes thru the rubber, until it was loose
enough to push center out. Then collapsed the metal shell with hammer &
chisel. Worked fine for me. Not too much abuse or chance to bend them.
rick schaefer
On Tue, 24 Jul 2001 10:37:03 -0400 [EMAIL PROTECTED] writes:
>
> Replies to this message are sent to The Chevelle Mailing List
> ------------------------------------------------------------
>
> Hi all;
>
> Have completed rebuilding the front end of my 71, now to the rear.
> Have new boxed lower control arms and sway bar. Have a question on
> the upper control arms. Book call for a special tool to remove the
> bushing on top of the axle, is it really needed or will hand tools,
> push and grunt work?...
>
> Thanks..Denny/GA
>
> -----------------------------------------------------
> To Unsubscribe please visit www.chevelles.net/list.html
> To start a new topic, send mail to: [EMAIL PROTECTED]
-----------------------------------------------------
To Unsubscribe please visit www.chevelles.net/list.html
To start a new topic, send mail to: [EMAIL PROTECTED]
