----[Please read http://ercoupers.com/disclaimer.htm before following any advice in this forum.]----In a message dated 11/17/00 3:51:44 PM Eastern Standard Time,
[EMAIL PROTECTED] writes:
I used 600 grit sandpaper and honed the mating
surfaces.
Re-assemble the parts using a special lubricant/sealant. For this purpose,
I
used a product made by United called "EZ TURN" (Part number EZTURN1LB)
mil spec# mil-G-6032D.
You can also use valve grind compound and lap the two surfaces together. The
lube is commonly called "fuel lube" and the caution is waranted. Borrow, not
buy it, because if you buy some, it'll last you 10 life times.
John
--------------------------------- to unsubscribe send mailto:[EMAIL PROTECTED]
___________________________________________________________ T O P I C A http://www.topica.com/t/17 Newsletters, Tips and Discussions on Your Favorite Topics
