I wonder if that's dependent on the chip. I have one of the old style with the upgrade chip and it ranges from 2400 to 57600.
73, Mike NF4L On 8/2/12 3:07 AM, Ian White GM3SEK wrote: > Don Wilhelm wrote: >> That will work ONLY if the SteppIR can listen in on 38400 bps traffic. >> If it needs any other speed, then you must put the "Y" on the P3. >> >> Check the data speeds that the SteppIR will handle. >> > The older SteppIR controller can only handle up to 19200 bps. That speed > must be manually configured in all three devices - the SteppIR > controller, the computer and the P3 - and the SteppIR controller MUST be > connected at the INput of the P3 (NOT to the K3) > > The connection between the P3 and the K3 will always be automatically > reconfigured to 38400 bps (regardless of the manual configuration > setting in the K3) so an older SteppIR controller cannot read the > traffic at this speed. > > The newer SteppIR SDA-100 controller can handle 38400 bps so it could be > connected to either the K3 or the P3, but again this speed must be > manually configured in all three devices. > > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html
