You are correct, my mistake. However the antenna selection should follow your radio regardless if you are using remoterig or not.
John KK9A From: Jorge Diez - CX6VM [mailto:[email protected]] Sent: Tuesday, November 14, 2017 6:59 PM To: [email protected] Cc: Elecraft Reflector Subject: Re: [Elecraft] sharing K3 RS232 to CAT and Remoterig Hi John thanks for the information N6TV Y box will work for ACC port, but I need something equal for RS232 port I use a Y cable to ACC to drive bandecoder and amplifier and works fine thanks, Jorge 2017-11-14 20:34 GMT-03:00 <[email protected]>: I use a Top Ten Band decoder to control a SixPak. This is connected to the RS-232 jack. I often have other devices(such as a MicroHAM DigiKeyer2) also connected to this jack using a N6TV Y-box. For two devices you can use an inexpensive Y adaptor instead. I have no experience with a remoterig box. John KK9A Jorge Diez - CX6VM cx6vm.jorge at gmail.com Hello At my station, I have Elecraft K3, Bandmaster III, SixPack, CAT cable connected to K3´s RS232 So when I change bands in the radio, antenna is selected automatically through CAT cable and band decoder (Bandmaster III) Today I connected remoterig box, so needed to remove CAT cable to connect remoterig. So now I lost the feature to change antennas automatically when I change bands on the K3 How can I do to share RS232 to have CAT and remoterig at the same time? thanks, Jorge CX6VM/CW5W -- 73, Jorge CX6VM/CW5W ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:[email protected] This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to [email protected]
