OK, I understand. The Bandmaster III obtains band information from your
K3 by sending commands that request it and decoding the replies from the
K3. That is, it's a 2-way communications. When the Remoterig box is
connected, it also sends commands and receives replies from the K3 ...
also 2-way.
I believe there may be a solution however. The Elecraft KRC2 band
decoder obtains band data from the K3 using the ACC port leaving the
RS-232 CAT port free for the Remoterig. The KRC2 would essentially
replace your Bandmaster. [:-(
This solution assumes that the KRC2 continues to produce band
information for antenna switching when the K3 is connected to the
Remoterig and in TERMinal mode. I don't know the answer to that
question, perhaps someone on the list does.
73,
Fred ["Skip"] K6DGW
Sparks NV DM09dn
Washoe County
On 11/14/2017 1:26 PM, Jorge Diez - CX6VM wrote:
Hello Fred
I lost automatically antenna change because I needed to remove my CAT
cable from K3 to connect remoterig. Of course if I removed remoterig
RS232 cable and connect CAT cable all is OK as I had it before
connecting remoterig
That switch A/B is not an option for what I am looking for, I need
both at the same time
thanks!
Jorge
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
