Jorge,
You cannot have RemoteRig and the K3 on the same COM port. You must use
2 different COM ports. Otherwise, the K3 drivers and the RemoteRig
drivers on the RS-232 connection will interfere with each other.
If you do a study of RS-232 mark and space voltages, you will find that
it is a point to point (one to one) communication. Other devices may
"listen in" to the communications, but they must have all drivers
disabled and set to a high impedance state. The K3 and the RemoteRig do
not meet that criteria, so they cannot co-exist on the same COM port
connection.
The only solution is to use 2 COM ports (one for K3 and one for
RemoteRig), and if they must synchronize, that will need to be done in
the computer - but I don't know of any software application that will do
that synchronization.
73,
Don W3FPR
On 11/14/2017 4:26 PM, Jorge Diez - CX6VM wrote:
Hello Fred
I lost automatically antenna change because I needed to remove my CAT cable
from K3 to connect remoterig. Of course if I removed remoterig RS232 cable
and connect CAT cable all is OK as I had it before connecting remoterig
That switch A/B is not an option for what I am looking for, I need both at
the same time
______________________________________________________________
Elecraft mailing list
Home: http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/mmfaq.htm
Post: mailto:[email protected]
This list hosted by: http://www.qsl.net
Please help support this email list: http://www.qsl.net/donate.html
Message delivered to [email protected]
