Geert De Pecker wrote: > Guys, > > I'm getting lost here: > > - attached the old 3 axis xylotex: same problem > > - hooked up the scope to watch the step signal: step high approx 3 us. > Should be ok as xylotex says 1000 ns minimal. 5 volts. > > - at approx 1000 Hz pulses seem ok. a little twitchy on the scope screen. > > - attached older pacsci motor: same problem. No torque at all. > > - voltages to the xylotex board ok: 29V and board gives proper 5 volts > > Don't know what next to do. Any hints more than welcome. > > Thx for listening, > > Geert
If you have very low holding torque even at zero speed, the most likely cause is low motor current. The xylotex boards have pots to set the motor current. Are you sure they are set correctly? If I recall correctly there is a test point, you put a meter on it and adjust the pot. The manual has a formula that lets you determine the proper test point voltage based on your motor current specs. Regards, John Kasunich ------------------------------------------------------------------------- This SF.net email is sponsored by the 2008 JavaOne(SM) Conference Register now and save $200. Hurry, offer ends at 11:59 p.m., Monday, April 7! Use priority code J8TLD2. http://ad.doubleclick.net/clk;198757673;13503038;p?http://java.sun.com/javaone _______________________________________________ Emc-users mailing list Emc-users@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/emc-users
