Hi All;
I have installed EMC 2.3 on a lathe using the Motenc Light interface.
Two problems have me stumped.
1- I want to Home at the Encoder Index after using Plus-limit / Home
combination Switch at the Plus end of travel to get to a known start
position. This is shown in the third homing diagram on the page
of four diagrams in the Integrator Manual INI file homing section.
I can't stop if from Homing at the "Home Switch release point".
Does anyone know how to make this work with my equipment?
2- When jog or any other travel hits a limit switch, is there any way
EMC software can get the axis off the limit switch?
Normally the limit switch disables all the axis drivers.
Thanks
Don
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
