Hi Steve;
I have the home configuration variables set as follows:
home_search_vel = .1
home_latch_vel = -.05
home_final_vel = -.1 ( the sign makes no difference)
home_ignore_limits = YES
home_use_index = YES
home_offset = 6.06
home = 6.00 (anything equal or less than
6.06)
(more than 6.06 moves it back onto the limit switch)
The next index mark is approximately 1.42 inches in the negative
direction from the Limit/Home switch and it always homes on the
"Home Switch release point".
I have tried everything to correct this including some imaginary
stuff. Nothing works! Help if you can.
Thanks
Don
----- Original Message -----
From: "Stephen Wille Padnos" <[email protected]>
To: "Enhanced Machine Controller (EMC)" <[email protected]>
Sent: Thursday, May 20, 2010 11:33 AM
Subject: Re: [Emc-users] Homing at a Encoder Index.
> EKCo Inc Don Stanley wrote:
> > Hi All;
> > I have installed EMC 2.3 on a lathe using the Motenc Light interface.
> > Two problems have me stumped.
> >
> > 1- I want to Home at the Encoder Index after using Plus-limit / Home
> > combination Switch at the Plus end of travel to get to a known
start
> > position. This is shown in the third homing diagram on the page
> > of four diagrams in the Integrator Manual INI file homing section.
> >
> > I can't stop if from Homing at the "Home Switch release point".
> > Does anyone know how to make this work with my equipment?
> >
> There are a few ini file settings that you need to configure for this.
> See the following pages on the wiki:
> <http://www.linuxcnc.org/docs/2.4/html/config_ini_config.html>
> <http://www.linuxcnc.org/docs/2.4/html/code_Code_Notes.html#sec:Homing>
>
> - Steve
>
>
> --------------------------------------------------------------------------
----
>
> _______________________________________________
> Emc-users mailing list
> [email protected]
> https://lists.sourceforge.net/lists/listinfo/emc-users
----------------------------------------------------------------------------
----
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.819 / Virus Database: 271.1.1/2885 - Release Date: 05/20/10
02:26:00
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
