Hi Andy;
The Lathe is a servo system, but it may have the same problem.
I wonder if using the limit switch as a home switch also, is
creating some bug trick.
WOW; The "Override Limit" checkbox is so obvious it's embarrassing.
I had noticed it as inactive, but I was so distracted (annoyed) by the
big RED X that I never noticed it was active when on the limit switch.
Thanks
Don
On 20 May 2010 04:24, EKCo Inc Don Stanley <[email protected]> wrote:
> I can't stop if from Homing at the "Home Switch release point".
> Does anyone know how to make this work with my equipment?
Is it a stepper or servo machine? I vaguely recall half of a
conversation about this on IRC the other night saying it was tricky on
steppers (for a reason I am not entirely clear on).
I think it might require clever juggling in HAL
> 2- When jog or any other travel hits a limit switch, is there any way
> EMC software can get the axis off the limit switch?
> Normally the limit switch disables all the axis drivers.
There is a checkbox "Ignore limits" on the axis main screen that
allows you to jog off the limits.
--
atp
----------------------------------------------------------------------------
--
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
----------------------------------------------------------------------------
----
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.819 / Virus Database: 271.1.1/2883 - Release Date: 05/19/10
02:26:00
------------------------------------------------------------------------------
_______________________________________________
Emc-users mailing list
[email protected]
https://lists.sourceforge.net/lists/listinfo/emc-users
