EKCo Inc Don Stanley wrote: > Hi All; > I have installed EMC 2.3 on a lathe using the Motenc Light interface. > Two problems have me stumped. > > 1- I want to Home at the Encoder Index after using Plus-limit / Home > combination Switch at the Plus end of travel to get to a known start > position. This is shown in the third homing diagram on the page > of four diagrams in the Integrator Manual INI file homing section. > > I can't stop if from Homing at the "Home Switch release point". > Does anyone know how to make this work with my equipment? > There are a few ini file settings that you need to configure for this. See the following pages on the wiki: <http://www.linuxcnc.org/docs/2.4/html/config_ini_config.html> <http://www.linuxcnc.org/docs/2.4/html/code_Code_Notes.html#sec:Homing>
- Steve ------------------------------------------------------------------------------ _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
