2011/4/30 Peter C. Wallace <[email protected]>: > On Sat, 30 Apr 2011, Viesturs L?cis wrote: > >> Date: Sat, 30 Apr 2011 18:17:10 +0300 >> From: "[UTF-8] Viesturs L?cis" <[email protected]> >> Reply-To: "Enhanced Machine Controller (EMC)" >> <[email protected]> >> To: "Enhanced Machine Controller (EMC)" <[email protected]> >> Subject: Re: [Emc-users] EMC2, 7I43, Hostmot2 >> >> 2011/4/30 Peter C. Wallace <[email protected]>: >>> >>> The /DONE not low usually means that the EPP port read failed >>> probably because of one of the following problems: >>> >>> 1. Port not really in EPP mode >>> 2. Parallel port - 7I43 Cable not right >>> 3. Port address wrong >>> 4. 7I43 not set to parallel mode >>> 5. No power or wrong 7I43 power >> >> I will try to find a multimeter to check, if the cable is ok, all the >> rest seem to be fine.
Thanks for the tip, it looks like 2 pins in the cable are bad! I have yet to figure out, if I made bad soldering on 25-pin PC connector or there is something wrong in the 26pin card's connector. Unfortunately it seems like that 26pin connector is not meant to be disassembled. > Well if you want to do it by yourself you need to download Xilinx webpack and > edit one of the PINXXXX_48.vhd files to change the pinout. YOu might look at > one of those PINXXX_44.vhd files in either Mesas or EMCs HostMot2 source to > give you an idea of what needed Ok, I will probably give it a try once I get the communication between EMC and 7i43 working. Viesturs ------------------------------------------------------------------------------ WhatsUp Gold - Download Free Network Management Software The most intuitive, comprehensive, and cost-effective network management toolset available today. Delivers lowest initial acquisition cost and overall TCO of any competing solution. http://p.sf.net/sfu/whatsupgold-sd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
