2011/4/30 Peter C. Wallace <[email protected]>: > > 2. Parallel port - 7I43 Cable not right >
Yupp, cut off the old 26-pin connector, installed new one, tested with multimeter - all the pins were OK, installed the cable and EMC does not complain any more! Now I have a question - how do I create 6 stepgens on 7i43 card? In INI file I changed the CONFIG line and set NUM_STEPGENS to 6, but EMC did not like it - error message told me that 4 is max number. So how do I make EMC reconsider? And how do I get step and dir signals to a particular pin of 7i43 (7i42TA) card? For software stepgens there are stepgen.n.step and stepgen.n.dir pins, that were "connected" to parport output pins in HAL file. But I do not see such pins for hm2_7i43.0.stepgen.0n in HAL Configuration, that I would have liked to connect to hm2_7i43.0.gpio.0nn.out What am I missing here? Viesturs ------------------------------------------------------------------------------ WhatsUp Gold - Download Free Network Management Software The most intuitive, comprehensive, and cost-effective network management toolset available today. Delivers lowest initial acquisition cost and overall TCO of any competing solution. http://p.sf.net/sfu/whatsupgold-sd _______________________________________________ Emc-users mailing list [email protected] https://lists.sourceforge.net/lists/listinfo/emc-users
